Auto Parts and Repairs
Car Computers and Sensors
Mercury Villager
Ford Bronco XLT

Why is the gas light always on in 1996 mercury villager where the sensor has been changed twice?


Top Answer
User Avatar
Wiki User
2007-11-09 20:34:10
2007-11-09 20:34:10

The indicator was not or cant be reset.


Related Questions

the elictronic control sinsor at on a 93 mercury villager

O2 sensors are always located on the exhaust system.

The cam sensor on a 1996 Mercury Villager cost about $35 to $40. The sensor is actually manufactured by a Nissan subsidiary.

the sensor on the 3.3l mucury villager is integrated into the distributor

on my 1999 ford mercury villager its on top of transmission under the van

can you tell me where the knock sensor is located on a 3.3l mercury villager

The speed sensor is at the top rear of the transmission housing.

If you mean the fuel level sensor it's in the fuel tank.

That is incorporated with the latch assembly.

Top rear corner of the transmission.

In a 1998 Mercury Villager, the mass air flow sensor is located in the air intake tube. The air intake tube goes from the air box to the intake.

The vehicle speed sensor is at the top rear corner of the transmission housing.

Cam position is taken from the distributor, there is no separate sensor near the cams.

Cam position is taken from the distributor, there is no external cam sensor.

The speed sensor on a 2000 Mercury Village is found on the transmission of the vehicle. The sensor will be placed on top of the unit to read the rotations of the transaxle.

On the top of the transmission housing at the back corner.

It is mounted to the rear of the throttle body.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.