The shift cable has failed.
Loosen the shifter cable not on each end of the shifter cable. The shifter cable will come off. Reverse the process to install the new shifter cable.
Remove the side fuse panels then un do the bolts from each side, 1 each, then pull out ashtray theres' two bolts in the back of that, two bolts in the top of the instrument panel, one bolt underneath the dimmer switch, one underneath the gear shift. Will need key in to pull shifter down to get it above the shifter, then on the side of dimmer switch you can disconnect,and relpace.
No. You have separate problems.
They have four struts, one for each wheel. Check out Dodgeintrepid.net for a ton of info on these cars.
There are 2 excellent write-ups on the procedures for replacing the shifter cable, one for floor shift and column shift each, at the Taurus Car Club site. See Related links below for more information.
on a 2.7L there are two camshafts on each head there located directly under the valve cover. on a 3.2L/3.5L there is one in each head there located in the head under the valve cover
The 1997 Chevy Blazer shifter cable will have swivel nuts on each end of the cable. Connect the shifter cable and turn the swivel nuts to the right to install the shifter cable.
Beginning of each shift
There are four oxygen sensors on a 2002 Intrepid. There is one before, and one after the catalytic converter on each side of the engine.
The 1999 Dodge intrepid brake lines schematics diagram shows the routing of each brake line. The diagram will show the brake line routing from the master cylinder to each wheel.
6, one on each plug.
The Volvo 960 does not use a cable type shifter, it uses a rod style shifter linkage. It is a rod from the shifter and one from the transmission connected by a long rod. There is a bushing at each pivot point.