I am answering my question to help others. The flasher unit was not working. It is located at the driver's left knee. This is to the right of the fuse box next to the blue relay. You have to remove the bottom panel to get to it. There are two Philip screws, you have to pull it down and out of its snaps. I plugged in the new relay and everything is working now.
turn signal switch needs replaced!
If the turn signals on a car works but the hazard lights do not there may be a problem with the flasher switch. The flasher is located in the steering column, and a damaged unit can cause the lights to stop working.
You may have blown a fuse or a flasher.
I had a similar problem with my 1991 Maxima. The dashboard lights did not work. I could not find a fuse. Then I noticed the parking lights did not work. I could not find a fuse. Finally I noticed the tail lights did not work. I checked the fuse and it was burnt. After replacing it all is okay again.
your hassard lites have a separate flaher relay change it.
first make sure hazard lights are not on.next you need to ckeck the grounds from the battery.
Try pushing the hazard light switch on steering column repeatedly. I had a strange problem with my hazards once and this fixed it for now. I think my problem was the signals not working though....
The turn signal and the hazard lights each have their own relay. Sounds like you have to replace both relays.
If your hazard lights don't work but your turn signals do work it could be that your Hazard Lamp Flasher needs to be replaced. Your car has both a "hazard lamp flasher" and a "turn signal lamp flasher". Your "turn signal lamp flasher" is working but your "Hazard Lamp Flasher" may not be working. Buy a new "hazard lamp flasher" and install it. The hazard lamp flasher is located behind the instrument panel to the left of the steering column.
It contains two relays, one for hazard lights and the other for turn signals. The one for the turn signals is defective and must be replaced.
bad fuse or hazard switch
try replacing all sets of fuses for the hazard and the tail lights.
Two different switches. The combination switch on the column is most likely the culprit. This may be fuses. The turn signals and hazard lights are fed by separate circuits.
Not typically. answer yes the hazard lights stop turn sinals from working there are only 2 elements in the bulb one for stop and one for turn hazars use same eement as turns signals it is for that reason that it is illegal in most states to actually drive with your hazards working they are supposed to be used only when stopped
Check your relay switches that should be located near the fuse box.
If lights light up but do not flash, then need to change the flasher, if no light at all chk all fuses first.
check your bulbs some bulbs have two filament on them one may be out and the other working.
Try turning the hazard flashers on and off a couple times, see if that starts your signal lights working. If so, replace the hazard switch/module.
Turn signal flasher?
If your 1999 Ford Expedition has turn signals that do not work but hazard lights that do work, it is likely that you have a fuse that is blown. You might also have a wiring issue including exposed wiring.
my daughters 1991 miusbishi montero has no break lights , turn signals or hasard lights . All tail lights and front markers are working. All fuses are cking good and all bulbs are good..Is my blinker switch bad ? capri
I'll check for a blown fuse(fuse relay box), ground problem, and your bulb.
Lights or signals fits this 'fill in the blanks'-type question..
It's the turn signal indicator-located behind the hazard lights.You have to take it out and replace it.
It probably has 2 Flasher Relays. One for the hazard lights and one for the turn signals. Replace the turn signal flasher.