0
Why is there a clunking noise in the passenger side of my 2004 Hyundai Santa Fe?
Wiki User
∙ 12y ago
Something is broken, loose or worn out
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Loud Clunking noise in front end 2004 Hyundai Santa Fe?
Could be the front wishbone. Mine was making similar noise, especially over bumps. Not a major repair - approx €250 euro
What makes a clunking noise in the back of the car?
chiken
What would make a loud clunk noise in a passenger side front tire when turning left?
If you operate a front wheel drive vehicle, the clunking noise you hear may be a CV joint bearing going bad.
Why do you hear a clunking noise when hitting bumps?
You need struts
What causes clunking noise from the autos shocks?
Bad shocks
92 chevy4wd clunking noise in rear?
probably your rearend
Car makes clunking noise when turning?
tie rod
There is a clunking noise coming from the right passenger side of my 1999 Chevy Malibu what could it be?
that is either your front right wheel bearing or your coil spring is turning need new suspension..$$$$
Why does your car make clunking noises when you step on the gas and the brake?
A car that is in good running condition should not make a clunking noise. If a person pushes the gas and brake pedal at the same time causing a car to make a clunking noise, that is an indication of stain on the motor.
Why does your car make a clunking noise by the front brakes when you put your car in reverse after parking on an incline?
A clunking noise, when you put your car into gear, is most likely caused by a bad u-joint. A problem in the transmission can also cause the noise.
What if your 91 firebird formula 5.0 has a clunking noise as the car speed goes below 30MPH If you press in the clutch before it drops below 30MPH the clunking noise does not happen?
If there is a clunking noise on a 1991 Firebird Formula 5.0 when going below 30 mph, and the clunking noise does not happen when the clutch is depressed, it is probably a problem with the flywheel. The flywheel moves freely when the clutch is depressed. When the clutch is not depressed, it could be that something is rubbing on the flywheel, like the clutch plate.
What makes a clunking noise when turning?
Wheel bearings or u joints
