Best Answer

Clean the battery terminals, posts, and check the battery for electrolyte compound. did you make sure to connect your hot wire back to the distributor cap If you had no spark before,,,,check the map sensor.

User Avatar

Wiki User

โˆ™ 2006-02-13 11:19:05
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Why is there no spark on a 1991 Grand Marquis after you have replaced the plugs wires rotor cap distributor module igniton coil and pickup coil?
Write your answer...

Related Questions

Your 93 caprice alles up and down and go dead especially when it rains?

igniton module igniton module

Electronic ac module on 2003 grand marquis?

where is the ignition control module located on mercury marquis

What can be the problem of a 1994 Chevy Suburban 1500 will not start even though spark plugs coil and distributor replaced and there is no spark?

Is it a brand new distributor ? If not then replace the module and pick-up coil in the distributor that you have.

Would a body control module shut down a car while in driving motion?

Maybe the igniton control module or the ignition module are making bad contact.

Where is your electronic distributor ignition module for Mazda 323 1987?

The module is located behind the Rotor Arm assembly in the distributor itself. You have to remove the Distributor Cap, then the Rotor Arm and the module is there.

2000 Chrysler Sebring has power to distributor but no spark to plugs?

It could be either the crank angle sensor or the distributor module. If it is the distributor module, you have to buy and install a re-man distributor.

How do you test the coil inside the distributor of a Chevy Camaro that has no spark?

chances are if there is no spark then the ignition module inside the distributor needs to be replaced as far as checking it goes just pop the module out and autozone or advance auto may be able to tell u where to take it to have it tested

How do you know if the pick up module is out?

You will have no spark from the distributor.You will have no spark from the distributor.

Where is a ignition control module a 1987 Chevy blazer s10?

The ignition module is located in the distributor, under the distributor cap.

94 b3500 v8 runs good then quits wait 20 min then it starts again does same thing changed coil and still the same when it quits dont get a spark from coil need help?

try changing the igniton module (dist. module) usually located on the base of the distributor. hope this helps!

How to replace crankshaft position sensor on a 1983 mercury grand marquis 302 v8 engine?

1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.

Chevy 327 electronic ignition module replacement?

The 327 cubic inch Chevrolet's distributor had points and condenser and not an ignition module. If you have an ignition module then you have a HEI distributor that was changed out.

Where is the ignition control module located on a 1992 Chevy Berretta?

ignition module is located under the distributor, where the spark plugs come out to go to the spark plugs, remove 6 bolts that hold the 3 capped distributor on, unplug the wires from both ends of module, 3 plugs, lift module out, nothing holds it in after distributor is removed, plug new module in, replace distributor.

Where is the ignition control module located on a 96 Chrysler Sebring Coupe LXI?

depends on eng size. The distributor contains the coils and module 3.0 and 2.5 if bad the whole dist needs replaced not servicable

Were is the ingition control module on your 1985 Chevy s-10 2.8?

The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor

Where do you locate the ignition module on a 1998 GMC Yukon with HO 350?

the module is in the distributor the module is in the distributor. you will have to remove the cap and rotor. it should be held on by 2 screws. good luck

What does the module do in the distributor?

It controls spark and fuel.

Where is the daytime running light module location grand marquis?

where dose daytime running lamp module go on92 mercury grand marquis need to replace one

Where is module located when distributor is installed 86chevy s10 2.8 v6?

inside the distributor

1986 grand marquis has power to the coil but no fire from the coil to the plugs the coil has been replaced and still nothing what else would be wrong?

Replace the ignition control module

Where is the igniton control module located on your 1998 gmc 1500?

That year did not have 1. It uses a crank sensor and cam sensor

Where is the ignition module on a 1995 Honda civic DX?

the ignition module is located in the distributor

Where is the ignition module on a 88 tracer?

ignition control module is under the distributor cap

Where is the electronic spark control module on a1993 Chevy 1500?

The ESC module is in the distributor

How do you replace an igniton module on a 2000 cavalier?

Disconnect the battery cables. Locate the ignition module. Disconnect wires and remove the screws. Remove the auxiliary components to reach the module. Remove the screws holding the module and remove it from its housing. Replace it with a new one.