Unplug your battery for a half hour.
Why is oil light on in 2000 sephia
they didnt make a sephia in 2005
If the motor is shaking in your Kia Sephia, you probably have loose motor mounts. Simply tightening these up will stop the engine from shaking and vibrating.
In my kia Sephia, the check engine light will go on, then when ignored it will eventually turn off. Then a day later it's back on. Shortly after that it starts to blink. usually the blinking means whatever the problem was is now no longer going to work. It's happened to me multiple times. It blinks and then 10 minutes later I'm on the side of the road waiting to get the piece of sh1t! towed!
How in the heck did you get a v6 engine in a sephia first of all!?!?!?!?
By repairing the problem that has set the light, and then using a OBD2 scan tool to reset the light. It may still be under warranty. Check with your dealer. Emissions warranties are longer than normal warranties.
Yes. I just installed an '02 Spectra motor in my '00 Sephia.
Trying to clear the check engine light in a Kia Sorento yourself is not recommended. The check engine light could indicate a serious problem and the car should be inspected by someone qualified.
take it to the autozone they check the engine light for free
If you look under the car, passenger's side, it should be right there up under the engine, or at least that is where it is on a 1998 KIA sephia.
Kia Sephia was created in 1994.
will a 2000 kia sephia dohc transmission fit on a 1995 kia sephia sohc block?
Under the engine in the middle toward the back of the engine
Get a wiring diagram from MOTORLIT.COM
you should check if the engine sizes are the same as in liters ect if all that matches it should fit just fine
One way to reset a Kia Rondo check engine light is to disconnect the battery for up to one minute. After the battery is reconnected, the check engine light should be off. If the light does not go off, there is a problem with the car and it will need to be checked out.
and what code does the check engine light say ? go by autozone they will check it for free and get the code.
The location of cylinder 2 on a 2001 Kia Sephia is the first plug wire of on the left side of the engine. The firing order is 1,3,2,4.
Unplug the battery
washer pump located on kia sephia
what is troble code p1611 on kia sephia
The taillights on a 1999 Kia Sephia are replaced through the cars trunk. Remove the plastic covers from the light housings and replace the bulbs.
Answer: If the CEL (check engine light) is doing this, then you have a wiring issue. So make sure it is the CEL light that is on. IF so , then you will need to take it back to where it was just recently repaired to have them look into it. This does not occur just by itself because the grounds for the CEL (being the module) and turn signal are separate.