answersLogoWhite

0


Best Answer

My sister's 2002 has the same problem. The first thing I would try is to change the fuse- look on the right side of the panel next to the glove box (if it is not there, check your owners manual). If you change the fuse and it immediately blows again then it is likely a short. I am still looking for a wiring diagram to try to locate it.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why might the dash and tail lights not work on a 1985 Buick Century?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you Change a fuel pump on a 1985 Buick Century?

How do you Change a fuel pump on a 1985 Buick Century?


How do you find the freeze plugs on a 1985 Buick Century?

where is a freeze plug on a 1985 buick lesebra


Cooling fan sensor on a 1985 buick century?

Check at the rear side of the radiator towards the top


Does fuel tank need to be dropped to replace fuel pump on 1985 buick century sta wag?

Yes


Where is the horn located on a 1985 Buick skyhawk?

where is the horn located in a 1985 buick skyhawk


Why does the power steering fluid in a 1985 Buick Century leak when you put it in?

The most obvious answer would be a broken hose which need to be checked.


Interchangeable motors how can you find out in a motor will work in different vehicles?

Will a 1987 Grand Am 3.0 motor fit in a 1985 Buick Century 3.0?


How do you change a low beam driver's side headlight on a 1985 Buick Electra Park Avenue?

To replace the lights in your car you need to unscrew the headlight cover on your Buick. Once this is removed you can unscrew and replace the old bulb.


When was Buick Somerset created?

Buick Somerset was created in 1985.


What century is 1985?

1985 was the 20th century.


How do you replace the bulbs for the reverse lights on a 1985 Buick Century?

Answer to how to replace reverse lightsU should be able to open ur trunk , and on the inside where the light are mounted should be some sort of screws , usually behing the carpet or whatever material is their. Once the screws are undone u should be able to slowly pull the whole light assembly out ( might require a littel tuggen if they havent been taken out in a while ) once that's done u should be able to replace the lights.


Why does 1985 Buick le Sabre die at stop lights?

Idk if you have a carb in that particular car, but besides the vacuum lines, check to see that the carb is torqued down to spec.