answersLogoWhite

0


Best Answer

Replace the fuel filter.

User Avatar

Wiki User

6y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why the Toyota 3f Landcruiser I only drive 15o meter then it cut out the engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where can you find an exhaust system diagram for a 2001 Toyota corolla?

where is air fuel meter on 2002 v-tech engine


91 Toyota land cruiser dashtail lights flicker then go out?

I have 1992 LAndcruiser and have same problem. I have been trouble shooting on and off for months now, I suspect a fault ground, does your Volt Meter fluctuate when you use the flashers? I have noticed unstable voltage readings...


How do you reset maint req light on a 2005 Toyota Sequoia?

turn key to on without cranking the engine then press the trip meter lever for a few seconds until the meter reads zero


How do you reset maint-req light on a 2005 Toyota sequoia?

turn key to on without cranking the engine then press the trip meter lever for a few seconds until the meter reads zero


Why does the 10 amp fuse labeled engine on my rodeo blow every five to ten miutes of run time?

there is a short in the wiring beyong the engine fuse this could be depending on vehicle your wiring to your windshield wipers, ignition switch, defogger, over drive switch combo meter or power steering on 1986 Toyota


How do you reset oil change light on Toyota Highlander 2012?

To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.


Where is the air temperature sensor on Toyota 4 runner 1997?

Not sure if the 97 has a cabin sensor or if this was what you were looking for. Yet the one for the engine is in the air flow meter at the air filter.


How do you reset the maintenance required light on a Toyota Venza?

Resetting the maintenance LightSwitch the display to the trip meter A when the engine is running.Vehicles with smart key system:Turn the "ENGINE START STOP" switch off.Vehicles without smart key system:Turn the engine switch to the "LOCK" position.Vehicles with smart key system:While pressing the trip meter reset button, set the "ENGINE START STOP" switch to IGNITION ON mode (but do not start the engine because otherwise the reset mode will be canceled).Continue to press and hold the trip meter reset button until the trip meter displays "000000".Vehicles without smart key system:While pressing the trip meter reset button, set the engine switch to "ON" position (but do not start the engine because otherwise the reset mode will be canceled). Continue to press and holdthe trip meter reset button until the trip meter displays "000000".


Where is the airflow meter on 92 Toyota pick up?

in the car


Replaced the battery and terminals and alternator and belt When at idle under a load the volt meter is fine But when trans is put in drive the volt meter drops and caused the dash lights to dim Why?

What is the reading direct from the battery with a volt meter when this happens. It should be over 12 volts.Engine at idle, in drive, with the normal load, yes, will have reduced volts until the engine turns faster.


How do you clear the Engine Service light in a 2000 Toyota Corolla?

Well my corolla need a new flow meter, new transmission oil and a belt tensioner, not sure which one fixed it though


How do you change meter light bulb for Toyota Previa?

open the meter, buy a new bulb , put it in holder , refix