answersLogoWhite

0


Best Answer

I had the same problem with mine it turned out to be a short i n the power seat mechanism. There are lots of other things that run through a thermal fuse. The haynes books have a wiring diagram in the back hope this helps

User Avatar

Wiki User

โˆ™ 2010-07-23 02:54:42
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Why the doors dont lock when you use them more than once?
Write your answer...
Submit
Related questions

How do you see someone elses wardrobe?

Open the wardrobe doors. If it has a lock, you will have to locate the key, pick the lock, or peek into the keyhole. Once the doors are open, you will then be able to see their wardrobe.


How do you reprogram a remote keyfob for a Renault laguna?

LAGUNA II RF RESYNCHRONISING1. Turn Ignition OFF.2. Press the central door locking button for more than 5 seconds. Note: the door should lock then unlock.3. When this happens, 15 seconds is allowed and the immobilizer warning light illuminates.4. Press the remote control once, the doors should lock and unlock.5. Press the second remote control once, the doors should lock and unlock.6. Check the remote control unlocks and locks the doors.LAGUNA II RF RESYNCHRONISING1. Turn Ignition OFF.2. Press the central door locking button for more than 5 seconds. Note: the door should lock then unlock.3. When this happens, 15 seconds is allowed and the immobilizer warning light illuminates.4. Press the remote control once, the doors should lock and unlock.5. Press the second remote control once, the doors should lock and unlock.6. Check the remote control unlocks and locks the doors.


Why when I press my wireless key entry all the doors dont unlock?

Press it once for the driver's door only, and again to unlock the rest of the doors.


Does the 95 Subaru legacy have an automatic door lock system?

I just bought one and it does...however, when you shut the drivers side door it pops the unlock button and unlocks all the doors. I have to put the key in the door and turn it to lock all the doors at once.


When you key less lock 2003 ford explorer doors it double honks?

That means a door is still open or the back glass/gate is open. it will beep once when the doors are closed


How do you activate the hands free locking on your Renault scenic?

pus and hold down the lock button on the dash next to the gear stick for about 6 seconds , you will hear 2 blips , once this uis done as your car gets to 6mph the doors will lock . pus and hold down the lock button on the dash next to the gear stick for about 6 seconds , you will hear 2 blips , once this uis done as your car gets to 6mph the doors will lock .


How do the doors lock when exiting your 1965 and1966 ply barracuda the key will lock it but to take the key out it comes unlocked whatever I do it will not stay locked?

That was a Mopar tradition at the time, to lock the car from the outside one has to use the key to lock it manually once the door is closed.


How do you make 2005 Honda Civic stop beeping every time you lock or unlock the doors?

uhh. if you have the factory keyless entry system (the Honda Key fob with three or four buttons) just press the lock button once. Your signal lights will flash once and doors will all lock. when you press it a second time the lights will flash again and the horn will beep. (This is done so you can confirm that they are locked - however you only need to press the lock button once in order to lock the doors. There should be no beeping sound when you unlock them. If you do not have the factory keyless entry system (if you have an aftermarket system such as Viper or CodeAlarm), you'll need to read the manual that came with that product. Happy trails


What is autolock or autounlock on a 2002 Ford Explorer?

The autolock feature will lock all the doors once the Explorer is in gear and the brake pedal is released


How do you lock the doors on sims?

I have tried a various amount of times and I have gotten it once, I forget what to do to do that though so sorry about that. I know you can in Sims 2.


Why do the power doors locks on your 98 Villager automatically lock Is there a fuse that you cannot find to replace?

That is just what happens. alot of cars have that. Once you go past 20 m/h they just lock.


What is a secret to skateboarding?

Never give up on a trick your practicing and once your finished do not celebrate and get drunk keep on practicing until you get it on lock and once you get it on lock dont keep on doing it add a sex change or do it of a ledge.


2003 Windstar SEL when you activate the door lock switch from either driver side or passenger side the doors will lock and unlock but if you do it more than once they get weeker and weaker?

Two different problems here..... The doors refusing to lock may be a problem with one of the door ajar switches. If any door is percieved to be ajar (whether it is or not) the system will refuse to lock the doors. My first question is are you getting a door ajar message on the message display? The fact that the locks get weaker is a simple exercise in physics. The doors are locked and unlocked by an electronic solenoid. This is basically an electromagnet. The more you hit on it the hotter the coil gets. Heat weakens the magnetic field in the solenoid coil. It loses its ability to pull the lock open or closed. Do it for long enough and you burn out the coil. This translates to big bucks. Carl


How do you lock the doors of a 1999 Mercedes SL500 once you are in the car do you just press the door button down?

On the inside door lever, you'll see a smaller lever above. Push that little lever down, that will lock both doors. This makes it nearly impossible to lock your keys inside your car. I think there were some models that had a door lock switch on the center console...but I doubt you have that model. And...there are no door button on SL's. Are you sure you have an SL? And one more thing...don't forget to get rid of that cat in the back seat.


What is the function of caps lock key?

Once you click the caps lock key in the keyboard of your computer, it can make one or more letters capital.


When I open my car door lock with key should all the doors also unlock too?

Typically, when you turn the key once in the driver's door, it unlocks the driver's door. If you turn the key twice, it unlocks all the doors.


How do you deactivate the automatic door lock above a certain speed on Hyundai cars?

You cannot do this yourself unless you have the scan-tool the dealer uses($$$$$$). So, take it to your local dealer and they can program the body module to not lock the doors once rolling.


How do repair the central locking system which suddenly stops locking such that one cannot lock the car?

Problems with falcons is usually the door lock actuators. they fail all the time. to diagnose. use key to lock doors. once locked, see which one will unlock by trying to open the door. if any of the doors open, the one that opens will be crook. ie, i had a car come in last week. Using the remote, the doors would lock and then unlock straight away so really the car wouldn't lock. i used the key and they all stayed locked but when i went to open the left hand front door, it unlocked the rest of the car. problem was the left hand front door lock actuator.


How do you program a remote key for a 2000 Chevy Tracker after battery replacement?

Resynchronize it by holding down both the lock & unlock buttons at same time for at least 7 seconds. Doors should lock & unlock once to confirm that resynchronization worked.


How do you program keyless entry remote for 1999 Lexus ES300?

Here are instructions: 1. Driver's door open and unlocked, all other doors closed and locked. 2. Insert YOUR key in ignition, DO NOT TURN, remove key. 3. Using the lock/unlock button ON THE DRIVERS DOOR, slowly press lock and unlock 5 times (count the lock 5 times and unlock 5 times). 4. Shut door. 5. Open door. 6. Using the lock/unlock button ON THE DRIVERS DOOR, slowly press lock and unlock 5 times (count the lock 5 times and unlock 5 times). 7. With the door open insert your key into the ignition, turn to on position (DON'T START), wait 5 seconds. Turn off and remove key. 8. Locks should cycle once (Car will lock and then unlock once). If they don't cycle or they cycle more than once, do steps 1-7 over. 9. Now using the remote, push lock button, hold for one second, release. The locks should cycle once. If not, start over and go slower. 10. Close the door. Open the door. Press the lock button on the remote. The locks should cycle. Close the door. Press the lock button on the remote, the doors should lock. Press again and the doors should unlock. Congratulations - You are done!


How do you lock and open the door left 4 dead what letter?

If you do not have keys for the doors in the game, you will not be able to open them. Even if you do have the keys, you have to use the key to open the door through your inventory menu. Once you close the doors, they are locked until you use the key to open it back up.


How do you program a key less entry remote control for a 1999 Mazda Millenia 2.5L?

1997-2000 You can program up to 4 remotes on this vehicle 1. Turn the ignition ON 2. Within 4 seconds press LOCK or UNLOCK of first remote 3. Within 4 seconds turn the ignition OFF 4. Within 4 seconds turn the ignition ON 5. Repeat steps 2 thru 4 twice 6. Within 4 seconds press LOCK or UNLOCK of first remote 7. The doors will now automatically lock and unlock to let you know that the programming mode has begun 8. Within 15 seconds press LOCK or UNLOCK of the first remote which allows the doors to lock and unlock once and lets you know that the remote is now programmed 9. Press LOCK or UNLOCK of each remaining remote (if you have any) allowing the doors to lock and unlock once as each remote is programmed 10. Turn the ignition OFF 11. Remove the key You will have to program all old remotes because the transmitter memory was overwritten!! 1997-2000 You can program up to 4 remotes on this vehicle 1. Turn the ignition ON 2. Within 4 seconds press LOCK or UNLOCK of first remote 3. Within 4 seconds turn the ignition OFF 4. Within 4 seconds turn the ignition ON 5. Repeat steps 2 thru 4 twice 6. Within 4 seconds press LOCK or UNLOCK of first remote 7. The doors will now automatically lock and unlock to let you know that the programming mode has begun 8. Within 15 seconds press LOCK or UNLOCK of the first remote which allows the doors to lock and unlock once and lets you know that the remote is now programmed 9. Press LOCK or UNLOCK of each remaining remote (if you have any) allowing the doors to lock and unlock once as each remote is programmed 10. Turn the ignition OFF 11. Remove the key You will have to program all old remotes because the transmitter memory was overwritten!!


How do you change the key lock on a 1988 Jeep Cherokee?

To the best of my knowledge.... When I replaced the locks on my 1990 cherokee, I took the door panel off and inside the door there was a c-clip with a tab that hold the locks in the doors. I used a screw driver and slid them out from under the cylinder. Of course you have to disconnect the linkage for the lock from the cylinder itself and then they just pop right out of the door. Dont lose the lil rubber seals that go between the outside of the lock and the door and be careful not to damage them because if you do not reinstall them with the new lock, they will rattle and the lock will move around in the door when you turn the key. The tailgate lock was a little different. But still pretty easy to do once I removed that back cover to get at the internals of the door.


Do tulips bloom more than once?

of course it blooms more than once just make sure chipmunks or other rodents dont eat them.


Remote start a Scion tC?

AnswerTry on the remote, UNLOCK + LOCK + LOCK. That should do it. After the car starts, just UNLOCK + UNLOCK to unlock all doors. Once you get in (without pressing pedals), just put key in and TURN to ON. Do not turn to START or you will attempt to start an already running engine. Not all Scion tC's come with this feature though. You may need to have andafter-market one installed.orThe remote engine starter is operated by pushing the `lock` button on the keyless entry fob in a quick, three-step sequence: (1) push and release `lock` button; (2) push and release `lock` button again; (3) then push and hold `lock` button for three seconds-and the engine starts. The engine can also be stopped remotely by pushing the `unlock` button once, or by pushing and holding the lock button for two seconds or more.