answersLogoWhite

0

  • Chevy Malibu
  • Heater Cores and Blower Fans
  • Car Heaters
  • Chevy Trailblazer

Why the first two speeds of the heat blower do not not work?


Top Answer
User Avatar
Wiki User
Answered 2006-10-23 04:08:53

Probably the blowere relay, may be the switch or the blower motor however. This is a bad resistor, very common problem on Malibus. It's located under the dashboard, behind the glove box. Here's a site from another forum with the specific directions: http://www.automotiveforums.com/vbulletin/showthread.php?t=175159 I had the same problem with mine. I went to a junkyard, and bought a used part to fix it. The part behind the dash that you use to change the speeds of the blower is what needs changed. It is actually very easy, and about $30. It is worth doing, I was done before I left the junkyard (I wanted to make sure theirs worked).

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Why does the heat blower only work on low and medium but not on high?

the blower resistor controls the fan speeds


What would cause the heat and ac blower not to work on 2006 trailblazer?

if all speeds do not work id say is a fuse, but if you just dropped one or two speeds. replace the blower motor resister. sells for $60.00 at the dealer.


1988 Toyota truck blower motor speeds won't work on low speeds?

The blower motor speed resister is burned out.


On a 2001 Pontiac grand prix gt how do you know if the heater blower motor resistor is bad?

Blower wont work on all 5 speeds, usually the lower speeds tend to go first.


When the blower does not work on all speeds is it the blower motor?

usually the blower motor resistor pkg. located on or near the blower motor


Why does only the HIGH blower work on my 1997 Nissan maxima?

Your blower switch sensor is out. Replace it!Then all the speeds will work


How to repair the high speed on my ac blower motor all other speeds work ok?

Normally when some speeds work and others don't, the problem is a bad, Blower Motor Resistor Pack. You will find it somewhere near the blower motor.


Why the Blower motor not work on high speed on a jimmy 97?

If the blower works on slower speeds only I would suspect the high speed blower motor relay (under the hood in the power distribution box) or the switch itself. The blower speed resistor is working if all the slower speeds work.


Why does the blower switch not work on low speeds on your 2001 Xterra?

bad resistor


1999 caviler and the fan blower motor only has 2 speeds low speed does not work how do you determine the problem?

change the blower motor resistor . this controls the speeds . thanks paul


What causes the heater blower motor in a 2003 Trailblazer to not work in speeds 1-3 but works in speeds 4 and 5?

Probably the blower motor speed resistor is partially burned out.


Why would our 97 lesabre blower work sometimes and sometimes not?

If the blower motor randomly and intermittenly quits and does not work, chances are good the blower motor itself is faulty, if the blower motor does not work on all fan speeds from low through high, it most likely needs a blower motor resistor.


How do you find fault on heater fan not workin mk3 mondeo?

If all speeds do not work, suspect the fuse, the switch, the switch connector or the blower motor. If only high speed works, suspect the blower motor speed resistor. If low speeds work and not high, suspect the blower motor relay.


Why doesn't fan blower speed 1 2 3 work and speeds 4 and 5 do?

the blower motor resistor is broken, get a replacement.


What is wrong with your 1997 s10 if the blower motor will not work?

If you have no blower speeds at all check the fuse, then check the blower motor switch and electrical plug for a melt down situation, then check the blower motor itself.


Why does the lower three heater speeds on a 1999 Malibu not work?

The blower motor resistor is defective. They go bad when the blower motor pulls to much amperage.


Why doesn't the blower on 2002 Jeep Wrangler work on 2?

If it works on some speeds and not others, the most likely problem is a defective Blower Motor Resistor Pack. It is located near the blower motor.


Why does the front blower only work on high setting but not low or medium on 2002 Chrysler Town and Country?

When the fan is on high it does not run through the blower motor resistor. The low speeds don't work because the blower motor resistor is bad.


Why heat blower does not work 96 ford explorer?

Because its broken


Why will the heater blower work on the 2 high speeds and not the 2 low speeds on a 1997 Chevrolet Cavalier and what part needs replaced and where is it located?

you need a new rheostat !


How do you get heater blower to work at different speeds on a cirrus car?

replace the resistor pack on the fanblower, under glowecompartment


What is the problem when the blower fans only work some of the time on a 1999 Alero?

Just had the same problem. First my blower motor would onlywork on "high", and then it started to change speeds and shut off by itself. Replace the resistor mounted in front of the blower motor.It costs about 40.00 at a dealer.


Why does my heat in my 1999 dodge caravan only work when you turn the heat on high?

a bad blower motor resistor heat normally used on medium and high medium usually burns out those speeds first till only high is left normally located right back under glove box on heater box/core line usually 20-40$


Heat will not work in the dash of a 1993 ford van the heat works great in the back blower How do you fix the heat problem from the front blower front blower will blow hot for a few seconds then cold?

heat works in back not in front front blows hot for a few mins then cold


Why does the Fan motor for Chrysler Sebring not work in lows speeds only 4?

The common cause is a failed blower resistor.