You need to have the system checked for codes. You will then know why the light is coming on.
You will need a engine scanner to do that. But there is a problem in the computer system--Emission system, and if you did not fix the problem then the light will just come back on again. Some parts stores will scan the engine for free.
The system is "reset with a scan tool. If the cause of the light is not repaired, it will come back on.The system is "reset with a scan tool. If the cause of the light is not repaired, it will come back on.
The check engine light on a 1999 Cadillac DeVille can be reset by disconnecting the battery for 30 seconds. The light will immediately come back on if the problem still exists.
in the back on the drivers side
It has to be done with a scan tool. Resetting the light without correcting the problem will be of no use as the light will come back on.
Just turn off the air back service light..
It comes out the back of the light housing.
If the SRS light comes on then you have a problem with the air bag system. If you do not have a professional repair the system the light will just come back on.
front bulb blown
THE EASIEST WAY TO DO IT YOURSELF IS TO UNHOOK THE BATTERY. iF YOU DO HAVE A PROBLEM THOUGH, THE LIGHT WILL COME BACK ON.
how to replace water pump on a 1999 chevy malibu 2.4
NONE.. You MUST put the 4L60E back in it due to the computer system in the 1999.
The only way to reset the service engine light on a Nissan without going to a mechanic is to remove the battery cables and touch them together. This will reset the system but it will not turn it off forever; it will come back on until you fix the problem.
On my 1999 there is a switch in the overhead console which can override the door and courtesy light switches. I often use it if one of the kids has fallen asleep in the back with the light on.
i have check engine light on code po171 system to lean i changed o2 sensor check engine light came back soon after, i heard that it could be fuel air ratio sensor,where is it located on 6cyl Toyota sienna, do you have any input thanks tony
It is shared with the Back-up light switch. Towards the front of vehicle on the transmissions. There are 3 in a row, it is the middle one i believe. If you unplug it, the back-up light will not come on.
There is no back light for the clock. The clock numbers are actually LED's - there is no way to replace them - the entire clock will have to be replaced.
tail light lamps are bad
Miss Nelson Is Back - 1999 was released on: USA: 1999
The back-up light switch is located on the top of the transaxle,just forward of the shift levers. Hope your a good at this
you open the trunk and pull back the liner you will see a few blots remove the blots and the light should come right out.
You may have hit the e-brake pedal slightly so it kicks the light on. Try pulling it back up manually.
The light is on because you have disabled the Vehicle Stability Assist (VSA). Push the VSA button to turn the system back on and the light will go out.
The tail light bulb on a 1999 Chevy Suburban is replaced by removing the retaining screws, pulling the bulb assembly away from the vehicle, and unscrewing the bulb. A new bulb can then be installed and the assembly screwed back in place.