answersLogoWhite

0


Best Answer

perhaps you not getting the amount of current needed to activate the flasher fast enough,or your flasher is located in a place where it gets too cold, you may try changing the flasher or insulating it.'''here's how a flasher works.'''

the flasher contains a bi-metal strip and a heating element. when the heating element warms up the bi-metal strip bends making contact, and allowing current to go thru.as the current goes thru the heating element cools down and breaks the circuit that's how you get the blinking effect.'''(all happens repeadedly in milliseconds)

User Avatar

Wiki User

โˆ™ 2011-09-13 16:26:14
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Why the turn signal light wont work when the engine cold but working fine when is hot Usually when it's cold the flasher and the light won't on until like 10 seconds?
Write your answer...
Submit
Related questions

How soon does the fuel pump stop working if you run out of fuel?

About 10 seconds after the engine stops running.


How soon will the engine stop if you put diesel in a petrol engine?

depending on how much petrol was in the tank and the length of the pipes it could take between 2 - 20 seconds before the engine stopped working


How do you change Emergency Signal Flasher Module?

The emergency signal flasher module can be found below the dashboard, on the drivers side of the engine compartment. The emergency signal flasher module simply plugs in and out.


Does engine light come on with ignition on fiesta td 02?

Yes, when you turn on the ignition the Check Engine light will come on for a few seconds to show you the light is working. It will go out if no problem is detected.


If the signal lights are not working on a 1996 Monte Carlo Z34 and no flasher or signal light indicator on the dash would this be because of a burned out bulb or would the flasher need replacement?

Before replacing the flasher you should check the fuses inside the car and in the engine compartment including fuseable links, then check for voltage in the flasher connector with the switch on, it may be that your switch is the problem. Newer cars use lighting control modules which would be the next place to check.


How do you check a check engine light on 1995 Honda Accord?

Turn on the ignition and look at the instruments. You will see the Check Engine Light come on for a few seconds and then go off. If you see the light it is working.


What is good working search engine?

Google is a good working search engine.


Where is the flasher on a 1999 Chevy Cavalier?

the headlight flasher is located under the dash next to the OBD plug in (that plug where they check engine codes) on the drivers side..


How do you check your check engine light on your 94 accord?

Turn on the ignition and look at the dash. The light will come on and stay on for a few seconds to let you know it is working.


What if the check engine light does not flash 1992 accord?

Normally it does not flash. It only flashes when there is a serious problem. It will come steadily on when there is a problem but it is not critical. It will come on for a few seconds when you first start the engine. This is to show you it is working.


Why is oil in the air cleaner on a 1986 Chevy 4.3L V6?

In any engine it usually means your piston rings are worn.


How are working the engine?

engine is working by using of three or four stroke . and its follow cycles.


If a transmission stops working does the power steering stop working?

The transmission and power steering are usually two different systems. The transmission drives off the back of the engine and the powersteering pump normally drives off a belt on the front of the engine.


What is the duration of Ivor the Engine?

The duration of Ivor the Engine is 600.0 seconds.


Where is the fuse for the hazard flasher on a 2000 town and country?

It is in the engine compartment, specifically in the fuse box.


Why hazzard lights keep blinking when engine is off?

Hazard lights are usually controlled by a manual switch [Push-ON, Push a 2nd time-OFF]. This is true whether the key, or engine, is on or off. The situation you describe suggests that you have inadvertantly engaged the hazard flasher switch [usually located on the steering column just below the steering wheel].


Why is your BMW 323I 2000 shakes when it starts cold for 20 seconds then the choke kicks in and the engine settles?

It is the VANOS working in conjunction with the cold start injector... once your engine reaches that proper temp, the "shaking" goes away.


How do i get a key out that is stuck in the ignition of a 1995 lebaron gtc?

I've had that problem with my lebaron, I usually just start the car let it run for 2 seconds then turn the key (turn the engine off) and then I usually can get it out.


Why is the image of the engine evoked by the poet?

The working of an engine...


Smoke coming from dipstick on peugeot 306?

Either the PCV (Positive Crankcase Ventilation) system is not working correctly or the engine has excessive "blow-by" usually resulting from a high mileage/tired engine.


Where is the turn signal flasher on a 1989 Ford Ranger 2.3 4-cylinder engine automatic?

The turn signal flasher is under the dashboard mounted on the lower corner of the fuse panel.


Where is the turn signal flasher for 2001 jeep wrangler?

The 2001 Jeep Wrangler turn signal flasher relay switch can be located beneath the dashboard. The switch will be on the drivers side of the engine compartment.


Where is a flasher fuse located on a 1997 Jeep Grand Cherokee Laredo?

The '99 flasher fuse is in the fuse box in the engine compartment and the flasher switch solinoid in under the dash on the left side. Hope this helps. The flasher fuse is located on the kick plate of the passenger side above the fuse box. I actually just replaced one too!


What is the duration of The Busy Little Engine?

The duration of The Busy Little Engine is 2040.0 seconds.


How long does it take a helicopter to get off the ground?

Depends on flight conditions, elevation, loads, if the engine is running and warmed up etc. but usually it's a matter of seconds.