Vauxhall
Timing Belts and Chains
Vauxhall Vectra

Why will the gears not engage and the cluch pedal is soft on a vauxhall vectra 2.0 16v?

012

Top Answer
User Avatar
Wiki User
Answered
2011-08-10 08:28:29
2011-08-10 08:28:29

probably the clutch cylinder is gone :(

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


You need to hit the cluch before you change gears


1) exsellerate out 2) cluch in (hold) 3) change gear 4) cluch out 5) ecselerate :D


because you have poped the cluch too much and the teeth that your cluch have, have worn out. so it has no grip. you need new gears.


Either gear box is knackerd, or its got the wrong oil in it, if the oil i too thick, it will feel like treacle to change certain gears.



They need to have that shape to engage the chian properly




when I try to engage gears of mower blades, the engine dies under the load. Read wheels also lock when fowrad and rear gears are engaged.


Is the car auto or manual? check fluidlevels first, have you noticed any burning smells prior to problem? Does it not engage in all gears including reverse?


Stick shift or automatic? any other gears work?


Boat trailer winches usually have a small 'L' shaped lever that locks a cog to engage/disengage the drive. These often rust up and are hard to move.


Yes. All automatic transmissions have a hydraulic pump to engage the gears. Saturns are no different in that regard.


Check the hydraulic fluid in the clutch master cylinder. It could also be a worn/warped clutch plate or a problem with the cluch hydraulic system.


The overdrive will not engage on a 97 Mitsubishi Gallant if the switch has been turned off or the transmission is defective. Often time the bands will become worn and prevent it from shifting into certain gears.


The clutch will not engage ,you will not be able to shift./// the clutch will not (disengage ) making it almost impossible to shift gears


clutch is used to engage or disengage gears wher as brake is used to reduce i.e to retard the motion.



The syncros are going bad. they help the gears line up when you shift


Check (or have someone check) the clutch fluid reservoir. The fluid may be low.


BAD clutch slave cylinder, wore out clutch and pressure plate.


gears, gears 2, and gears 3


Simple, you put the transmission in D and that is all you have to do. With a Manual you have to engage the clutch and shift through all the gears over and over as you drive.


To engage the 4x4 manually (VTM-4), you would need to be in 1st, 2nd, or reverse gear. In those gears and while stopped, you can then press the VTM-4 button, and will engage 4x4. It will only be engaged when around 18mph or lower. Above that, and it will disengage. It will re-engage when it dips down to that speed again. To turn it off, you can just press the button, or shift to a higher gear Keep in mind that even with the button off, VTM-4 will engage occasionally when there's slippage.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.