The odometer runs on the same electronic gear driven sensor as the speedometer so if the speedometer is working and the odometer is not the problem is in the "Speed head" (speedometer unit in the dash). Mine and several others I have seen break at about 40,000 and will need replacing.
replace 1996 nissan 200sx se 1.6 tension pulley
how do i fill my trans fluid in 1996 nissan 200sx 1.6 l manuel trans
115
GA16de
My 1996 200SX SE holds 12 gallons of fuel.
$125 to $140
Yes
YES ... you don't even have to read to much into the book to find out either ... It says it on the cover of the manual it's for a 1996 Nissan 200sx ES ...
what motors interchange with a 1996 Nissan 200sx 2.0
11254 mph
you cant.
NGK Iridium, is the best set of spark plugs for 200SX
There is no such thing as an "odometer sensor." There is a vehicle speed sensor that is located on the output shaft housing of the transmission. That sends info to the speedometer. From there, the speedometer and the odometer are both operated internally, so if your speedo is working, but the odometer isn't, you have a problem inside the speedo head assembly.
Yes it has a timing chain not a timing belt.
alternator is not working so your battery isn't getting a charge
Valvoline gear oil 80W-90
The 1996 Nissan 200 vehicle speed sensor can be found on the back of the transmission. The vehicle speed sensor will be in the upper left-hand corner of the transmission.
Replace the speedo head assembly. It is a sealed unit, with no servicable parts. If the speedometer is working, then the cable and the speedo drive gears are working. The failure must be inside of the speedo head assembly itself.
take the acr to the body shop. It is a cheap fix and they have the expertise.
There is a plug on the from on the tranny on the top. Take a funel, put it in the hole and put the gear oil.
Follow pos batt cable to the end. it is in flywheel/trans area under pass side bottom.
Vacuum leak ?
its under the intake and i would wipe it down with a rag if it needs it you might have to clean the line though
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
There isn't a "cable" like there used to be. The speedometer/odometer is controlled by an eletroic speed sensor. A wiring harness plugs into the back of the dash module containing the speedo.