answersLogoWhite

0


Best Answer
Copy

Remove the serpentine belt , runs alt , AC and such try to start if starts, and probly will, check to see which pulley or unit is seized up Alt AC water pump

2011-09-13 17:06:50
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Add your answer:

Earn +5 pts
Q: Why will your 98 s10 not turn over checked starter and replaced solenoid has new battery turns too slow to start when jumped by another vehicle drift starts though connections good at terminals?
Write your answer...
Submit

Related Questions

You get a click when you try to start your 1985 Chrysler The battery is good and it will start right up when you get under the car and jump the solonoid connections with a screwdriver Is the solenoid?

solenoid is bad ,have it replaced,but check for remote solenoid first some vehicles have another solenoid mounted closer to battery


Your 1998 Ford Expedition Eddie Bauer 4x4 has trouble starting at different times acts as if the battery is dead The battery checks out as wellas the alternator What could the problem be?

Got to check the connections. The connections at the battery as well as at the solenoid/starter. There may also be an ignition switch problem but this would likely cause other problems as well. The connections should clean and tight and if your battery terminals are an after market type the part where the cable goes inside the terminal needs to be checked and cleaned if it can be disassembled. The starter solenoid is usually mounted on a fender close to the battery in the engine compartment and are notorious to cause failure and often times intermittent failures as well (one time it works another time it doesn't).


What causes a Chrysler 300 to stall if all the sensors have been replaced and fuel pump also?

Another possibility is loose or corroded wiring connections.


When starting car what if it just clicks?

That means the solenoid IS working, but power is too low to turn the starter. Check and if necessary clean or tighten the battery terminals. If still the same, charge your battery on slow for at least 12 hours, or get another battery.


Why do bulb have two terminals?

One Terminal Is for Positive And Another Is Negative Wier . Bulb Can't Glow Until Both The Terminals Are Connected


86 Ford F-150 keeps frying starter solenoid?

high resistance in your battery cables and low resistance in your starter from over heating or reversed battery connections at one time or another the combination togethe would create a large arc across the solenoid internal contacts possibly welding them togeter or over heating the solenoid winding resulting in no contact plate movement or starter running out of control


What is the proper placement of the wires on the starter solenoid of a 1983 Ford Thunderbird?

Looking at the solenoid from the front, and working towards the left, the right terminal will have one wire that goes down to the starter. The little push-on wire (usually red) will be the one that goes next. There may be another little push on, or a couple of wires with terminals- they all get attached to the next small terminal. The last terminal on the left of the solenoid is where the battery wire, and any other accessory wires go.


Mazda 323 f clicking and wont start battery was disconected to charge?

Its likely either the battery connections (terminals) are dirty, or where they connect is...or the battery while showing a charge is bad when on a load. If it starts with a jump from another car...it's the battery.


Does a 99 Mitsubishi diamante have an egr solenoid or just the egr valve. If it does have the solenoid where is it related to the valve?

Yes, the Diamante has an EGR solenoid. On any Mitsubishi, if the car has an egr valve, it has a solenoid to operate the valve. Just follow the vacuum line from the valve and it will go to the solenoid. There may be another one way valve between the valve and the solenoid, though. The solenoid is electronic.


Your Nissan Titan makes a clicking noise when you try to start it?

Start with the easy things first. I had this issue and it was a loose battery terminal. The terminal had corroded to the point that the battery made poor contact. I cleaned the battery connections, but could not get the connector tight enough to make a good connection. I eventually replaced the cable (under warranty). The battery also had to be replaced as it had been drained and recharged so many times, it had lost its umpph. Another possibility is a bad starter solenoid or a bad starter. Good Luck!


What is another example of a parallel circuit?

Another example is a switch, bulb, solenoid, and a motor. When the switch is turned on current flows through the bulb, solenoid and motor simultaneously. This causes the bulb to light, the solenoid to the activated and the motors spindle to rotate, all at the same time.


Your 2003 suburban won't start It is not the battery What can be the problem?

What are the symptoms? Will it turn over? Can you turn the headlights on and are they bright? IS there a clicking sound? Did you clean the battery connections? The side terminals really need to be clean to send the best current to the starter especially in the winter. Try cleanign the battery connections FIRST before you go any further then check back with another posting on what you have checked.


Where is the solenoid starter on a 1988 Chevy s10 blazer?

It is mounted on the starter motor itself. When you get another starter, it will have the solenoid mounted on it already. If it is bad, just replace the starter, I would not change just the solenoid.


Where is the Shift A solenoid on Chevy Z71 1997?

It is located above the pan in the transmission. There are two identical solenoids located beside one another, Solenoid A and Solenoid B, and if I remember correctly from when I changed mine out it is located toward the front of the transmission. They are small, rectangle shaped and are both held in with clips. I didn't know which was which, so I just replaced them both while I was at it. They run around $20 apiece at your local auto parts store.


What is the selinoid attached to a 95 Ford F-150 starter?

it should be your starter solenoid. Your positive terminal on your battery will have one wire running from the battery to a terminal on the solenoid. (there might also be a few more smaller wires leading to that terminal from under the engine) Another wire should be leading from the opposite terminal on the solenoid directly to your starter. There will also be one or two smaller terminals on the front (one labeled "s" and "i". the one labeled S will have a much smaller wire leading to your ignition on the column.


Put key in ignition it turns a little but 1994 grand voyagerLE won't start but lights turn on it does not even click?

Go clean the battery connections, recharge the battery and then start. The connections you have now are just enough to turn on lights but not good enough to draw the power needed to turn the engine over. Clean the terminals and connectors and make sure they are tight. If after you clean the terminal connections it stil won't crank, then you probably have a dead cell in yoru battery but try the connections first before you go buy another battery.


You replaced the battery and still car 2003 BMW 325i wont start?

Then you have a corroded or loose cable connections or possibly a defective starter. Another possibility is a defective ignition switch. I am assuming the engine will not turn over.


What is reciprocity theorem in antenna?

If a voltage is applied to the terminals of an antenna A and the current is measured at the terminals of another antenna B, then an equal current (in both amplitude and phase) will appear at the terminals of A if the same voltage is applied to B.Ref:http://www.cv.nrao.edu/course/astr534/AntennaTheory.html


What is another word for replaced?

exchanged (for)


Why does your 95 Hyundai accent not kick out the starter solenoid even after being replaced?

the stater motor needs replacing it is not the solenoid that does not kick out it is the gear on the shaft sticking in the flywheel so either the starter is worn, the gear on starter is worn, or the teeth on the flywheel are worn if you replace stater, make sure correct number of teeth on gear or you will just mess up another one


What is another name for a coil on an electromagnet?

A 'solenoid' is another name for a coil of wire that acts as an electromagnet when an electric current passes through it.


How many terminals has electric cell?

An electric cell contains two terminals.one is positive and the anotheris negative.


What potential (voltage) exists between two power supply terminals if 5 joules of energy are required to move 10 coulombs of charge between the two terminals?

Half a volt, because the energy is the charge times the potential difference.Another AnswerYou should be asking what the 'potential difference' is between the two terminals, not the 'potential'. Note that 'voltage' is another term for potential difference.


How do you replace starter solenoid on 1990 ford mustang?

The solenoid is on the driver side fender well next to the battery. You can buy one at kragen or another automotive store for around $20.


Which company developed Microsoft Excel?

Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.Microsoft developed it, releasing the first version in 1985. It replaced another product that Microsoft had called Multiplan.