Best Answer

ignition controll module

2007-05-09 15:34:41
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Why won't my 1991 gtz will not start I have changed the maf CPU cranks posi sensor oil psi switch I have 40 psi on the fuel rail it runs for a little while then it dies need help asap?
Write your answer...

Related Questions

Why is it when I replaced my ignition switch in my Cadillac Catera my car just cranks and cranks but will not start?

its not your ignition its your crankshaft sensor that's the same problem i had.

2002 grand caravan sport cranks but no spark?

Some possible problems when your vehicle cranks, but won't start are a bad crankshaft position sensor, or a faulty ignition switch. Another possibility is a loose or broken wire that runs from the sensor to the PCM.

Instrument panel not working 2002 F250 cranks but wont start?

changed cluster checked all fuses and they aer good no bad or broken wires going to o/d switch

Where is the speed sensor wire located on a 2000 infiniti i30?

The speed sensor wire is connected to the speed sensor and goes to the speed sensor relay switch. The speed sensor relay switch is connected to the computer by a separate wire.

Can anyone tell you why you may briefly get a check engine light when starting up The computer code says throttle positon switch but this has now been changed and it still does it?

I had the same problem, so I changed the throttle position sensor and the camshaft sensor as worked for me, hope it works for you too. also change the map sensor that was the reason the light was on

The same problem her the radiator is clean now and the thermostat changed but still the red light continues to switch on although the water level is good.i also tried to clean the switch.?

your coolant level sensor is bad. change it.

Cannot shift out of park in vw eurovan?

its probably your brake light switch. jiggle the little sensor connected to the top of the brake pedal.

What could prevent a 2001 Ford Ranger that cranks fine from starting anti-theft bad oil pressure sensor?

no spark check neutral safety switch / clutch "engaged" switch (?????) emergency fuel shutoff switch bad fuel pump ( should be able to hear that engage if you just turn the key one click forward but not to start)if its an automatic try it in neutral

Where is the tempetaure sensor switch located?


What is the cause of your Ford E350 abs light being on and how do you get it off?

the rear abs light sensor will stay on until the rear sensor is changed. this sensor is called a rear speed sensor, it cost about 25 dls for a new one. code eleven on code read out by veh's computer. a second cause can be a bad stop lamp switch code 13 on computer read out. this switch is about 15 dls and is located by the veh's brake peddle.

You want to disconnect your outdoor lighting that is on a movement sensor to just a regular offon type switch how do you do that?

There should be a switch on the light itself to disconnect the sensor.

1996 where is the ECT sensor Camry 1996?

The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.

Why engine light not on?

"Check Engine" light comes on when you turn ignition switch on and should go off when engine cranks.

How do you reprogram a motion sensor wall switch?

I have a outside motion sensor light and I need to re program the wall switch.How do I reprogram the wall switch? Thank you

Another name for transmission range sensor?

Talk about identity crisis... This thing has 3 names:Neutral safety start switchTransmission range sensorManual lever position sensor/switchUs old-timers probably relate more to the neutral start switch though...Another name for it is PRNDL switch. Sounded out like "perndal switch"

Where is the oil pressure sensor switch on a 2008 dodge caliber?

The oil pressure sensor on a Dodge Caliber is under the intake manifold on the front of the engine.

1993 Grand Am engine cranks but does not start No spark No power to instrument panel gauges when key is in the on position?

ignition starter switch

1992 Acura Legend Car cranks but when you let go of the key it shuts off?

Your ignition switch is worn out. you will need to replace it.

What is difference between limit switch and proximity sensor?

A limit switch turns on or off when the object being sensed reaches a specific location.A proximity sensor returns an analog signal indicating how far the object is from the sensor.

How does a photocontrol switch work?

A photocontrol uses light to activate the switch. When the sensor does not detect light the circuit is broken and the switch is deactivated.

Why do a Toyota Corolla fans continuously run?

fan motor could be grounding internally Unplug the fan switch and ground the wire if the fan stops replace the switch. If not you have an open between the coolant sensor (switch) and the relay. The coolant sensor for the fan is not the same sensor for the computer/fuel injection.

What do code P0870 mean on a dodge neon?

Trans fluid press sensor/ switch c sensor

What is a trs sensor on a 1998 ford Windstar?

Trs is transmisson range sensor-(neutral safty switch)

2002 Jeep Grand Cherokee Engine cranks but is a no start No dash gauges?

A 2002 Jeep Grand Cherokee engine that cranks but is not starting and has no dash gauges is experiencing an electrical system failure. This can be a result of a faulty ignition switch or damaged wiring.

98 ford explorer cranks but wont start?

Things to check: 1. spark, 2. crank sensor, 3. fuel pressure, 4. pcm codes, 5. fuel pump filter, 6. Inertia cut off switch, 7. fuel pump regulator. M.Swick