0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
2003 Mazda staling it run good but when i idle at a store for a while and try to good fast it start jerking but i restart it and it runs .but if idle again same old stroy. please help?
im sorry but your store is so last year!!!
Why won't 1999 Mazda B2500 idle correctly when started cold?
your truck wont idle correctly when its cold, because its cold...and nothing runs correctly when it's cold. your truck wont idle correctly when its cold, because its cold...and nothing runs correctly when it's cold.
Your BMW 325i idle goes up and down when you stop but the car runs good?
More than likely it's your Idle Control Valve.
Your 1986 Mazda b2000 runs fine but will not idle any suggestions have new carb plugs cap rotor fuel pump?
I have an 89 Mazda b2200 and all i did was mess with the timing and it started to run better,a but a friend suggested that I pull the distributor shaft and turn it a notch.
Why does Geo Prism engine vibrate at idle?
If it vibrates at idle and runs good under under full throttle, you have a vacuum leak. It can also be defective spark plugs or plug wires.
Your 1997 Mazda 626 run good only when cold?
My Mazda 656 DX 1996 purrs when it's cold. It runs terrible since I moved to South Florida.
How you adjust idle on 302 fuel injected it stalls wont idle but runs good need set it up?
Well FORD is a pos, Fixed Or Repaired Dailiy Found On Road Dead
1994 Mazda 929 doesnt idle properly?
I have a 1989 929, when its cold it runs real bad but once warmed up it has problems idleing, the car shakes and sometimes when stopped it stalls, mine is an auto, but when driving like on the highway it runs fine. Is your problem similar?
1992 Saturn runs good when cold misses when warm?
Does it miss on acceleration or at idle? If on accel I would be looking at the plugs and wires
How do you adjust the idle on a 90 300zx?
The idle adjustment screw is on the back of the motor on the driverside. stand on the driverside up by the brake master cylinder look under the vacuum hose that runs on the back of the intake. the idle air screw is there under the hose. good luck!
Your 94 4.3 astro misses so bad it will not idle but runs good when you give it gas?
check vac hose's for damg. or hole
1990 Toyota Camry with a rough idle?
I have 200,+ miles on the car. I change the plugs and wires yet it runs rough at idle and runs smooth at crusing speed. What can i do?
