answersLogoWhite
Alarm Systems
Ford Expedition Eddie Bauer
Ford F-150
RuneScape

Why wont your alarm control work after changing the batery?

192021

Top Answer
User Avatar
Wiki User
Answered
2006-09-15 06:20:52
2006-09-15 06:20:52

If it's an aftermarket alarm, you may need to reprogam that remote to the module. The settings have gone back to factory default. If you have your owners manual still, try reprogamming the remote. If that doesn't work, check fuses, maybe something didn't agree with the re-hooking of the battery.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


my alarm keeps going of and wont start.


(7 Ford Mustang wont start anti theft alarm wont turn off


Your alarm icon being on indicates that there is an active alarm.


Your alarm icon being on indicates that there is an active alarm.



disconnect the main wire from your car alarm


my hand set wont unlock my doors with new batteries and when i unlock the door with the key and open it the alarm sounds and wont let me start the car


Need help to disarm the alarm on 1999 infiniti g20


my ford f-150 truck alarm wont shut off


a loud alarm and one that wont let the car start is good.


is it just blaring and wont stop or it wont let you start the vehicle?


if have the alarm code then take it to the agents and you can overide it


my Nissan sentrs 1997 that wont start i think its the alarm systerm how do i overide the systerm


i replaced the ignition coil and the starter but the batery is dead but wen i went to start it the oil was shooting out of the carborator.


if you did disconnect the alarm, it wouldn't let you start the car because of the immboliser



The factory fitted alarm on a 2003 Corolla will not arm if the wires have been cut to the alarm. If the vehicle was purchased used, this is a good possibility.


The factory alarm can not be disabled. If you can not disarm this alarm, the switch on the door key cylinder has failed or is not connected.



I don't know if this will help, but I had a similar problem and it was a short in the light switch. Because the alarm was wired into the light switch. I wiggled the switch and it started. Change it.



Need to take van to a Chrysler dealer and have alarm system retrained.


could be a problem with your alarm, have you recently installed a new car alarm? Have it checked out by your dealer.


it could possible be yes, did you have a alarm on the car and now it wont activate, you just installed a alarm, you dont know if it has a alarm or not (but you think it does) these are questions i will need to help diag. your problem.


I replace engine but now it wont start.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.