IT is low on fluid or the clutch cylinder is bad or the slave cylinder on the transmission bell housingAnswerOR the pressure plate colasped-OR linkage is broke - but only if the slave cylinder is moving. AnswerUpon further inspection I have found out that I have a leaking steel line from the clutch master cylinder to the slave cylinder. Thanks again for the replys!!!!
What if the pedal is pumped and the pressure returns then works properly? could this be from low fluid or something to do with the reservoir or a leak in the line?
The C2500 is 2wd and k2500 is 4wd.
The wires going into the AC pump 1995 Chevy K2500 are the red-marked wires.
The rated horsepower of a 1999 K2500 Chevy truck is 255. The base engine is a V-8 that is 5.7 cubic liters.
The gross weight of a 1988 Chevy Silverado K2500 with a 5.01 engine is about 2.5 tons. This is equal to about 5,000 pounds.
Need to know what year and model the truck is. 1992 Chevy k2500
Check the manifold, just before the headpipe.
Its on the front of the crankshaft in front of the timing chain.
how do you change a pump water on a 2004 Chevy truck k2500 hd
Disassemble the dash, open up the HVAC compartment.
The 1998 Chevrolet K2500 Suburban is able to tow up to 6,000 pounds. Standard features include power steering, and tinted glass.
Yes. Look in the yellow pages for aftermarket a/c's
5.0 305 Small Block Was Standard On These.
Oil and filter change - 7 quarts. 6.6 quarts with a 454
i believe it is on the driver side frame rail under the cab
there is no choke it has idle air control valve it is tbi corect
A 2000 Chevy Silverado K2500 with 6.0 Vortec engine.
Engine block heaters were optional.
If it is an automatic then it will be the 4L80E in it. I'm not sure about the Manuel transmission type.
You should check the timing and plugs.
GM doesn't use one...buy another fuel pump
You need a refrigerant recovery system so take it to a garage.