Best Answer

It might be that your main fuse is blown or a bad ground. Can't think of anything else it could be.

User Avatar

Wiki User

โˆ™ 2010-04-11 04:40:39
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: Why would a 1990 Ford Crown Victoria not get power at the relay box?
Write your answer...

Related Questions

If a dodge neon would race a crown Victoria?

if a dodge neon would race a crown Victoria the neon would start of faster but after a while the power of a v8 engine the neon will get left behind the crown Victoria has great acceleration

Can a 1989 ford crown Victoria Transmission fit in a 1993 ford crown Victoria car?

No, the 1983 - 1992 Crown Victorias used the AOD transmission and the 1993-1994 Crown Victorias used the AODE transmission, so they would be different. Sorry!

What would you spend on a used Ford Crown Victoria?

Crown victorias are a popular car often used by law enforcement in the past. Deciding what to pay for a used Crown Victoria depends on things like how old it is, how many miles it has and the condition.

Why would the abs light come on in a 1994 crown Victoria?

Problem with the ABS system.

How do I adjust lifters on a Crown Victoria?

Most have hydraulic lifters and there would be no adjustment needed.

How do you install a air compressor in a 1995 crown Victoria?

donno but it would be nifty AND useful to have!

Why would cylinder 5 and 6 not fire on a 1999 crown Victoria?

Check for spark.

Why would a ford Crown Victoria temp gauge not work?

Cause it doesn't have one

What is heavier 97 explorer or 98 Crown Victoria?

I would assume the 1997 Ford Explorer is heavier than the 1998 Ford Crown Victoria ( especially if the Explorer is 4X4 or AWD or has the 5.0 liter V8 )

Where is the O2 sensor bank 2 sensor 2 on a 1997 crown Victoria?

Bank 2 is the drivers side of the engine in your Ford Crown Victoria Sensor 2 would be in the exhaust after the catalytic converter ( downstream )

Where is bank 1 sensor 1 on ford Crown Victoria?

Bank 1 is the passenger side of the engine on your Ford Crown Victoria Sensor 1 would be in the exhaust close to the engine before the exhaust enters the catalytic converter

What would cause a squealing sound from passenger side of a 2000 crown Victoria?

Have u checked the bearings?

How do you change the oil in 1997 Crown Victoria?

If you have to ask then it would probably be better to take it to a business that knows how.

What are the biggest wheels for a Ford Crown Victoria?

22" would be the maximum before you had to lift and modify the car.

Where is the drain plug for 1996 Crown Victoria?

Would that be the drain for the oil? If so, its on the bottom of the oil pan.

Would a intake on a Crown Victoria make it faster?

Not very much maby 5 -10 hp

Where is the edis located on a 1996 ford crown Victoria made in Canada?

EDIS , stands for Electronic Distributorless Ignition System That would be the ( 2 ) coil packs with spark plug wires on a 1996 Ford Crown Victoria that is part of the EDIS

Were is the bank 2 downstream oxygen sensor located on 2002 ford crown Victoria?

On a 2002 Ford Crown Victoria : Bank 2 is the drivers side of the engine Sensor 2 ( downstream sensor ) would be in the exhaust after the catalytic converter

How much money does it takes to fill up a 98 crown victoria?

A 1998 Ford Crown Victoria has a ( 19.0 U.S. gallon gas tank ) So , if the tank was empty and you pay $ 4.00 per gallon it would cost approximately $ 76.00

Can 26 inch rims fit crown Victoria 1997?

You idiot.. Why would you put 26" wheels on a crown vic??? You have to be kidding me! You would look like a complete fool driving around like that- I would point and laugh at you!

What were the problems with the Ford Crown Victoria police interceptor car model?

The Ford Crown Victoria police interceptor car would catch fire after a high-speed rear collision. Also the steel wheels would rust and the rack and pinion steering units would fail prematurely. The weld points in the wheels would come loose.

How many hp does a crown Victoria p-71 produce you would like toknow every year from 1996 from 2008?

I own a 2001 Crown Victoria P-71. The '01 cruisers put out 239hp and top out at 130mph (chip limited).

What would make your low-beams not work while the high-beams work fine on your 1989 Crown Victoria?

Bulbs burned out? Bad switch? Blown fuse in power distribution box

Will a 454 fit in a 1999 ford crown Victoria?

Why would you want to put a Chevy 454 in a ford in the first place

What does a wrench warning light mean on a 2010 ford crown victoria?

I would have to believe it means you need to have your care serviced.