Chevy Camaro

Why would a 1995 Camaro 3.4 liter run fine without the cam sensor connected but run rough when the wire is re-connected?

222324

Top Answer
User Avatar
Wiki User
2004-11-12 09:41:55
2004-11-12 09:41:55

It needs to be checked out with electronic equipment. Take it to a garage.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you change a crankshaft position sensor on a 1999 chevy camaro z28?

User Avatar

The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.

User Avatar

No, it uses speed density the 2.8 v6 camaro uses a MAF sensor.

User Avatar

That year did not have a crank sensor.

User Avatar

There is no crank sensor on a 1986 camaro z28.. that sensor is in the camaros past 1988 i believe.. but the 1986 carb or fuel injection (tpi) does not have one

User Avatar

That year did not have a MASS AIR FLOW SENSOR / ( MAF )

User Avatar

The MAP sensor on an '86 Camaro with a 2.8 liter engine is located by the distributor at the rear of the intake plenum. There will be a black plastic casing that needs removed to gain access to the sensor.

User Avatar

On a 1999 Camaro, the map sensor is located on the back of the intake manifold. The intake manifold is the series of tubing that distributes the air coming into the engine.

User Avatar

The difference is a sensor network may be connected using wires or wirelessly, a wireless sensor network is always connected wirelessly.

User Avatar

The throttle position sensor is located on the throttle plate.

User Avatar

mass air flow sensor or manifold pressure sensor. your car will have either or.

User Avatar

Sensor is located on the drivers side of the oil pan.

User Avatar

It does not have one on that year.

User Avatar

The speed sensor wire is connected to the speed sensor and goes to the speed sensor relay switch. The speed sensor relay switch is connected to the computer by a separate wire.

User Avatar

I want to know where the low and high pressure ac sensors are on a 1993 camaro

User Avatar

The oxygen sensor on a Honda Civic is replaced by disconnecting the wiring harness and removing the sensor using a socket wrench. Anti-seize paste is applied to the threads, a new sensor is torqued into place, and the wires reconnected.

User Avatar

the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.

User Avatar

On both the V6 and V8, the sensor is located in the plastic intake tube just infront of the MAF sensor. The intake sensor has a 2 wire connector.

User Avatar

Gas sensor? Not sure what you mean, could it be a Fuel gauge sensor? Oxygen sensor? Fuel pressure regulator?

User Avatar

On the driverside exaust manifold under the hood

User Avatar

It is right next to the oil filter

User Avatar

under the manifold, there are two (2)

User Avatar

To the right of the thermostat housing


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.