I am almost certain that the brake has nothing to do with it. I surely would check the fuel filter and replace it if you haven't in the past 2 years. If the check engine light is "ON" then have it diagnosed.
The instructions on how to reset the brake maintenance light in a Chevrolet Malibu can be found in the owner manual. It can be viewed for free at Chevrolet's official website.
I am changing rear disc brake pads on a 2004 Chevrolet Malibu lt can I get step by step instructions to make it easier for me.
It is on a bracket under the dash and above the brake pedal.
The 1999 Chevrolet Malibu brake light switch can be found beneath the dashboard, next to the brake pedal. The brake light switch simply plugs in and out.
it is on top of brake pedal in back.
the brake light switch is on the top of the brake pedal arm. under dash.
the switch is located at the top back of brake pedal!!
If it is not a low fluid condition then you will need to pressure bleed it.
If your brake is leaking,Its easier to replace with rebuilt ones,then to change the piston and seal,. And you should change both
The light should be controlled by a switch operated by the emergency brake handle. The switch could be out of adjustment or could be bad.
The emergency brake is partially depressed, even though the brake light is not on. release with handle and pull up on the brake pedal.
go into your trunk and you will see little black tabs on the inside un screw those tabs the brake light will then pop right out...