Mine has a similar issue when the rear window hatch releases (for no reason it will just pop open). In order to shut off the interior lights while I'm driving there is an "override" button to the left of the steering wheel on the dash. If I hit that then I get all the same symptoms you described, the rear washer does not work because the "rear hatch is open", the remote won't work and the radio will shut off when I stop the car until I close the rear hatch and hit the "override" button again. Hope that helps.
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
Replace the battery in the remote
Replaced the battery in the remote.
IF MY GARAGE DOOR REMOTE IS NOT WORKING AS WELL AS IT ONCE DID, IS THERE A BATTERY IN IT THAT NEEDS TO BE REPLACE??
It is possible the battery in your remote is dying...that signals a fail to start and a Check Engine Light for low remote battery voltage
Change battery at official dealer.
Check the battery in the remote.
If its on a charging console with the rechargeable battery it is probably overcharged if its battery is a normal battery then go to a game stop and get somebody to check it
You can if the key has a door lock/unlock button. I lock mine all the time with the remote. If you have the button on the key and it is not working then maybe the battery in the remote is dead? Open it up and replace the battery.
To get a match for a specific remote on a 2003 Trailblazer you will need to order it from a dealership. Any dealership that sales Trailblazers will be able to order you a new remote.
I got a new battery for the engine and my remote quit working.
You open the remote and replace the battery.
mine has a duracell DL2032.. working fine..
some car alarms have a backup battery in them. thses batteries if worn out can stop the alarm working.also sometimes the battery in the remote needs replacing to work
Don't know if the 2 are connected but the remote not working anymore generally means that it needs the battery replacing, the lift gate (Auto ?) needs a fuse (?)
You do not have to reset the keyless remote after battery replacement.
Remotes for automobiles can stop working for a variety of reasons. First check the battery, then reprogram if this is not the answer. Check with a mercury dealership to have the remote evaluated.
I had a problem too when I removed the battery from my Mentor's remote . Do the following ,sit inside the car , remove the remote battery , wait for 1 minute , replace the remote battery when doing so you will see that the remote light is on ! If the light is not on try again ! Now press and hold the lock button on the remote until you hesar the doors lock . Your remote is now programed .
There might be something wrong with the circuit board or something that connects the bateries x
all you have to do is click on the battery while it is in the remote. hope it helos you!
It is the same if you have can recharge your battery or you buy disposable, the Bluetooth remote may require a AA battery or a Lithium 3.0V coin battery. It will depend on what type of remote you have.
The reason that the remote key fob not working is that the battery is dead. The owner's manual should recount the process of replacing it. It could also be worn out.
Cut open the remote with xacto knife , unsolder and replace the battery.
Batteries aren't in properly. Battery contact points dirty. New batteries are faulty.