answersLogoWhite

0


Best Answer

probably damaged the crank sensor, or the tangs on the harmonic balancer

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would a 92 Buick LeSabre not run turn over after Serpentine belt shreds?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you route the serpentine belt to bypass the AC compressor on a 1993 Buick lesabre What size belt do you use?

I had a 1995 buick lesabre and the A/C compressor went out in the winter time. I waited until spring to replace the compressor. In the mean time, I used a Dayco 72.10 inch belt and bypassed the A/C compressor and it runs fine.


How do you replace the heater core in a 1999 Buick lesabre custom?

how much would it cost to replace the heater coil on a 1999 buick leSabre


How do you replace a rear wheel bearing on a 1994 Buick LeSabre?

I have a shimmy or small vibration while driving the interstate on my 1994 buick lesabre - if i was to check the front and rear bearings - how would i do that and what would i look for


FAQ10what would cause a 1994 Buick LeSabre v6 to shut off my self going down the road?

what would cause a 1994 Buick LeSabre v6 to turn off going down the road.


What is the spark plug gap for a 2003 buick lesabre?

The spark plug gap for a 2003 Buick LeSabre should be set at .060 inches. The best spark plug for this vehicle would be an Iridium plug.


Ideas about how to pimp out a Buick lesabre?

Ruin it the way you a "pimped out" car usually would be


Why would a 1993 Buick LeSabre stop running and not turn over?

Check battery and cables


What type of freon is in a 91 Buick lesabre?

Would have been built for R12, can be converted to R134a.


Why would power stay on buick lesabre 2003 when engine off?

you havent taken the key out of the ignition.


What type of freon does a 1992 Buick LeSabre use?

Would have been built for R12, can be converted to R134a.


Will ford rims fit on Buick?

My 1993 buick lesabre rims fit perfectly on my dad's 96 ford ranger, so I would have to say yes.


On average how much would it cost to replace the brake pads and rotors on a 1992 custom Buick Lesabre?

It is important to know the cost of replace the parts of a car while owning it. The average cost to replace brake pads and rotors to a 1992 Buick LeSabre as a kit would be about $300.