1986 Ford Bronco V8 302 EFI's have two fuel filters, one which is mounted near the rear of the transmission and the second one which is to the front mounted on the frame. The one which is mounted to near the back has a filter which looks like a old style round air filter approx. size is 2"X2" tall. ==New Answer Headline== An XLT at low speeds can also "buck" because of: 1)failing u-joints; 2)4x4 gears slipping/engaging; 3)clutch/gears slipping or sticking in transmission
They were available either with manual or automatic transmissions.
The horse power of the engine of the ford bronco automatic 1971 model is 205, with a top speed of 117 mph.
if its an automatic, and a four speed, E4OD?
3 speed automatic ( C6 ) 4 speed automatic ( E4OD )
Bronco II Eddie Baur Edition are Automatic Transmission..unless someone has swapped it after-market.
I believe that is a ( C6 ) 3 speed automatic transmission with the 351 in a 1989 Ford Bronco
If the F-150 has the Ford E4OD transmission, then yes, it will fit into the Ford Bronco. If it has the E6 automatic, however, you may have some issues.
First it would help to know if it is an automatic or a manual trans, then the question would be easier to answer.
to my knowledge the bronco is an automatic, so you dont have a flywheel. you have a flex plate and ring gear.need to know why you want to replace this
I wold check your automatic choke first.
The C5 Transmission
my 1984 bronco with a 5.0 and automatic transmission weighs about 5200lbs. Options on yours may be different making the weight slightly different. but it would only be slightly different.
4 speeds for automatic 5 for manual
Probably not because the Ford Bronco and Ford Bronco 2 were not very good by their motor.
No there isn't. The Ford Bronco and Ford Bronco II have not sold very well and The Ford Motor Company is not interested on making a Ford Bronco III because of this situation.
It would most likely be a/ worn clutch/s or a shift solenoid. ( yes!!! automatic transmissions have clutches)
Ford Bronco was created in 1966.
put it in 4x4, and it does it for you. or install locking hubs for 50 bucks.
If you are speaking of the full-size Bronco, then no. The automatic in the Bronco was either the E6, AOD, or E4OD, none of which were utilized by the 1985 Ranger. The Ranger used a few different types of Mazda and Mitsubishi transmissions in 1985.
no the bolt pattern is different and the bronco wheels would fit an f150 tho
What are the weight specs for a 1988 Ford Bronco Eddie Bauer 351 ci 4x4 xlt automatic 3 speed?
The Eddie Bauer was an option ordered from Ford. It was the top of the line Ford Bronco from 1987 to 1996