the Fan motor will keep running fort a short time after the car is shut off. the motor actually gets hotter after it is shut off so the fan cools it for a few minutes before cutting off. Actually, on all the mid 80s 300zx engines, there is a fuel injector cooling fan that directs cooling air on the injectors for a specific amount of time after the car has been run at normal operating temps and then shut off. Is your car a turbo z? If so then the fan that comes on is the fan that cools off the turbo after the key is shut off. Maybe you have an aftermarket fan set up for the air conditioner, but there again they usually come on while idling with the air on, but they generally shut off when the key is turned off. The fan is not used for cooling the turbocharger. The turbocharger itself is watercooled and does not have a need for a fan. The electric fan is for cooling the fuel injectors as mentioned in the previous post.
just do revers process of the motor.
diagram of a nock sensor in a 300zx 1996
VG30DETT is in the 90-95 Nissan 300zx. It is a v6
Electric energy is turned into mechanical (aka kinetic energy) AND HEAT
you have an electric motor on the transfer case unplug it and see if you have power going to it if you do the electric motor needs replaced
Type your answer here... earthing of electric motor is earthing of the electric motor which means to earth the motor that's electric
it is going two disk magnets force is going to make the coil spin
There are many different ways. On an outboard motor it can be a rope, pulley or an electric motor. Inboard engines are usually bigger and have electric, pnuematic or hydraulic starters. They can also be turned over with a hand crank if not too large.
Yes my car is a 1990 300zx with a 2008 350z motor and 6speed transmission
3.0 Nissan motor 3.0 Nissan motor
An electric motor is made up of magnets .. some electric induced magnets , some permanent magnets . the electric magnets are arranged so that when the power is turned on they activate in a series of pulsing magnets.. this pulsing causes the magnets in the core and the magnets in the body of the motor to repel and attract as magnets will do .. this repelling and attracting causes the magnets to try and chase each other around .. this action is turning the core of the motor and producing the rotating action expected from an electric motor
An electric motor need to be supplied electricity to operate. It can be made to generate electricity if turned by an outside force when set up correctly.
That sounds like an electric motor.That sounds like an electric motor.That sounds like an electric motor.That sounds like an electric motor.
what is the question? If you are asking if you can, the yes, if you are asking if it is difficult, yes again, if you are asking how, you have to disconnect the motor from the transmission and lift the motor so you can get to the turbos(on the bottom of both sides of the motor), and replace them from there. ------------------------------------------------------------------------------------------------ This question is stupid. Anyone who has a 300ZX TT knows the car enough to know the answer to this. I bet some idiot from Wikianswers.com is going around asking stupid questions.
First of all, what voltage are you going to use and second, what is the horsepower of the motor?
I know for sure that it is also in the maxima
In a dc motor, when the supply is suddenly turned off, there is a suddenly fall of speed in motor. this is reduced by means of electric effect. Hence it is called electric braking ( By @FarajAlyami electric motor braking has two types 1- electromechanical 2- electrical but electrical has some types as : 1- regenerative 2- dynamice 3- plugging ( counter - current )
Yes, but the DC current generated needs to be turned into AC first.
The electric motor changes electric energy into mechanical energy.
Power plants (fueled by elements) produce the electrical energy that circuits to an outlet that you can charge an electric motor with a plug that is wired to an electric motor. Or if it is a vehicle with an electric motor, you electrically charge car batteries that produce the current to the electric motor.
Get a wire tester and start at the window motor. If it has electricity going to the motor, then the motor is burned out. No electricity, follow the wire to the switch (and so on).
No its not worth it unless ur going to do a tt motor swap. check out www.z1motorsports.com
Because that is the purpose on an electric motor.