Why would nothing happen when you push the overdrive button on the column on a '89 Mitsubishi Mighty Max with a 2.0 engine and auto transmission?
Someone has to check out the wiring for the trans.
You can add transmission fluid to your 1989 Mitsubishi transmission through the dipstick holder. The dipstick holder should have a bright yellow handle.
The Mitsubishi 4G64 "wideblock" 13 1/4 inches between the lower Transmission Mounting Bolts, most commonly used in RWD Trucks, Mitsubishi Mighty Max and Dodge D50
I have no clue where voltage regulator is at on 1994 Mitsubishi mighty max can you help?
Mitsubishi 2.3L 4D55 Turbo
with a floor jack.
If your 1991 Mitsubishi Mighty Max dies after you start it up it could be one of several issues. There can be issue with the batter, fuel relay, or distributor.
Timing belt replacement on 88 mighty max
Need a diagram to set the timing Mitsubishi 1991 pu
Autozone or Advance parts
go to kbb.com
The firing order for a 1991 Mitsubishi mighty max 3.0 v6 is 1, 2, 3, 4, 5, 6. The number 1 cylinder is on the front left.
A bad battery, distributor, or fuel relay can all cause the 1991 Mitsubishi Mighty Max 2.4 truck to die after start up.
if its carbuetated then its on the motor cause its mechanical
Could be ignition module
3 1/2 quarts.
nope..it is an interference engine
Mounted on top and inside the fuel tank.
$ 62.00 at Auto Zone.
either radiator plugged or blown head gasket
1-2-3-4. Something like that.
to fill the tank i think 35 gallons
It sells NOTHING
Check the fuse.
6 x 139.7 (6 x 5.5)
It is closest to the radiator for the 4 cylinder engine motor.
69 Ft/lbs or 95 Nm
when my 89 mighty max did this I had to push the tailgate in while I opened the handle. Once open adjust or graphite the connections
mitsubishi recommend 1000kg for a 4x2 and 1500kg for the 4x4.
Mighty Med - 2013 Pranks for Nothing 1-5 was released on: USA: 28 October 2013
Mighty Med - 2013 Pranks for Nothing 1-6 was released on: USA: 4 November 2013
yes it does i know im trying to find a new one
On the transmission you will see electrical wiring connected to it.
i need to know the timing marks on Mitsubishi pick up 1991 2.4 one cam
Best I have found is in the Chilton Manual 50500, Pick-ups 1983-95.
In front of the fuel tank. You will likely have to remove the rear driver side wheel to get to it.
on drivers side under the dash behind fuse block
When making any changes to a car, it is important to have a diagram to help. A 1987 Mitsubishi Mighty Max wiring and vacuum hose diagram can be found in its maintenance manual.
Should be right next to the fuel tank underneath the truck bed.
yes, most 87's came with bech seats so it should be eazy for you.