answersLogoWhite
Ask
Transmissions and Drivetrains
Transmission Fluid
Buick Skylark

Why would reverse not work in a 1991 Buick Skylark after changing the filter and fluid but 1st 2nd and 3rd gears shift normally?

343536
Answer

Top Answer
User Avatar
Wiki User
2004-09-10 09:25:19
2004-09-10 09:25:19

I have no idea what went wrong. Take it to a trans shop.

1
0

Related Questions

User Avatar

It is possible that the fuel line in the 1997 Buick Skylark is bad. Getting a tune-up or changing the fuel filter may resolve this problem.

User Avatar

instructions for replacing air filter on 1989 Buick Skylark 4 cylinder

User Avatar

You can safely drive any car 3,000 miles before changing the oil/filter if it is driven normally. I drive normally and change my oil/filter every 5,000 miles. Follow your owner's manual recommendation.

User Avatar

The fuel filter is coming out of the fuel tank underneath the center rear of the car. Normally right around the rear axel. It looks like a sideways pop can. It is normally connected with on one side with a slide on clamp and on the other side is threaded.

User Avatar

Locate the fuel filter on the 1996 Skylark frame rail. While covering the fitting with a rag, loosen the fuel lines, and remove the filter. Take the filter off, and connect the lines to the new filter, keeping the flow arrow towards the front of the car.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.