Chrysler had a recall for the clockspring in the steering wheel of the van. I had the same proble. Get it fixed asap because the air bag probably won't work properly if it is not fixed. Also check your cruise control and horn. My did not work.
The airbag computer has detected a malfunction and set a code.
sounds like the clock spring is shot Take it in for service, the airbag system is not for diy'rs.
The check engine light on a 2000 Plymouth Grand Voyager will come on when an error is detected by the vehicle's computer. The cause can range from low oil to mechanical problems or incorrect timing.
You should get this checked with a special machine that will read a code claiming the error for such problem.
The airbag light turns on when the airbag computer detects a malfunction and sets a code.
The light come on when the system detects a problem and sets a trouble code. You should have it diagnosed by a trained technician. The airbag system is not for do it yourselfers. The light is on because there is a problem with the air bag system.
The airbag light stays on for a couple of reasons. 1. If the computer detects a malfunction and sets a code. 2. If the computer loses power (blown fuse) 3. If the computer loses the connection to the warning light the light comes on.
Defective computer these vans are known for this
Just above the brake pedal. The switch sets against the arm of the pedal.
how do you reset change oil light on chrysler grand voyager minivan 1997
Look behind the door handle pocket and the light or reflector on the panel.
Bad bulbs they are double filament or Bad stop light fuse or bad stop light switch
The sender is in the tank and something is wrong with it. It probably needs a new sending unit.
i had the same problem i just cut one of the wires leading to the switch that was causing the problem
The door being open.
The problem is most likely the clockspring. Go to this link it will tell you what to do. http://www.automotive.com/1997/49/plymouth/voyager/recalls/38659.html
it is a warning light of course
The maintenance required light requires a scan tool to be reset.
If it were me I would take the air bag back out and make sure the wires arn't "pinched" or broken and make sure that it has a good tight connection with the clockspring connector. If that doesnt solve it then the airbag control unit has failed for somereason. Hope this helps some.
The light will not turn off until the failure is repaired. The airbag computer has detected a malfunction and set a code.
Possible answerIs the airbag idiot light illuminated on the dash? There is a recall concerning airbag/clockspring failure on the 97. My horn failed when this repair was needed. Don't have cruise control on my vehicle. AnswerThis is caused by the clock spring inside the steering wheel behind the airbag. There is a recall for this problem. Take your car to any Plymouth dealer and it will be fixed for free. Call them first so they will have the clock spring in stock.
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
You should bring it in for service to a trained mechanic. The airbag light comes on when the computer has detected a malfunction.
the reverse light switch is usually mounted on the shifter inside the car.
2 screws, up/down. left/right