First, reset the computer by disconnecting the negative battery cable for a couple of minutes then reconnect. If the CHECK ENGINE light still comes on, check the gas cap and make sure it is tight. Due to emission rules (OBDII), the computer checks to make sure the gas cap seals the gas tank. You might have to replace the gas cap.
In a pre OBD 2 vehicle the check engine light comes on when there is a emissions failure in the vehicle the failure is usually due to one of many sensors which control your fuel delivery system in that vehicle. There is 2 exceptions though such as a dead cylinder in the engine or a heavy ignition misfire causing the engine to push unburned fuel through the exhaust causing a O2 sensor to read rich all the time and the computer will think there is a problem with the sensor and turn on the check engine light on
It could mean a lot of things. First rule with check engine light is go to Auto Zone or Orielly's to get it checked. They will give you a print out of what the error code is.
Have vehicle scanned to determine the problem usually in the emission control system
If you mean service engine light, then take off the gas cap and put it back on correctly. The fuel system is pressurized, if the cap is not on tight the check engine light will come on. At least three clicks.
No, the check engine light does not come on because your gas is half way full. The check engine light will come on if there is a problem with the engine.
no a burnt out headlight will not cause a check engine light but if you go to most of the part places they will check the check engine light for free
Should be on the small, black tank, attached to the inside of the passenger side wheel well inside the engine compartment. Should be covered with a small, black screw-off cap.
Check the hydraulic fluid reservoir for the clutch master, it may be low/empty. Filling it may get you by for awhile but you probably have a leak in the system and it should be fixed.
disconnect the battery
sending unit in tank
The check engine light for the 2001 Isuzu Rodeo often comes on because of a sensor that is damaged or malfunctioning. The most common sensor is an oxygen sensor and when reset, this often allows the light to be reset.
how do you find out how to check the transmition in a isuzu rodeo
A flashing check engine light means that you have a problem with your engine that may cause harm to the catalytic converter.
My check engine light has been on for one month but last night my check trans light flashed off and on about 3miles till I was home. Why and what do I need to do? I have a 2000 Isuzu rodeo.
get a new one
Have it checked for codes with a scan tool.
The check trans light may light up in an Isuzu Rodeo, because there are problems with the transmission, The light will show up on the cars dashboard.
Knock sensor needs to be replace
well u have 2 blah blah,.mml;jhnj
The check engine light on a 1997 Isuzu Rodeo could mean a failure in the ignition system has been detected or one of the cylinders has misfired. Hooking an OBDII code reader to the vehicle can determine the exact cause.