Auto Parts and Repairs
Headlights Tail and Brake Lights
Ford Explorer XLT
Turn Signals and Hazard Lights

Why would the hazard lights and left signal in a 2000 Pontiac Montana not work when the headlight switch is on?

303132

Top Answer
User Avatar
Wiki User
2004-12-09 05:07:27
2004-12-09 05:07:27

Check the left turn signal bulb. It is probably burnt out.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The switch is located on top of the steering column.

User Avatar

you need to change the flasher can for the signal lights

User Avatar

If all of the dashboard lights do not work at the same time on a Pontiac Montana, check the instrument panel relay. The relay is located on the firewall in the engine compartment.

User Avatar

Yes, there is a fuse for the interior lights on a 2000 Pontiac Montana. The fuse box is located to the far right of the dash on the passenger side. Open the passenger door to access it.

User Avatar

To adjust the headlight assembly on a 2002 Montana Van you will need to loosen the side adjuster screws located to the left and right of the headlight. With the lights on use a garage door or solid foundation to see if the lights are level. Once you have the headlight in a desired position tighten the adjuster screws to secure the light in place.

User Avatar

If you want to turn off the running lights off try to engage the emergency brakes. I have a 2000 Montana and that works.

User Avatar

To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.

User Avatar

If The lights stay on all the time when the car is off, you probably need to replace auto headlight relay.

User Avatar

On the '92 sunblrd SE the power for the lights to from fuse to headlight switch to dimmer switch to bulb, no relay involved.

User Avatar

check the overhead switch make sure its on if not that you have a blown fuse

User Avatar

It is the fuse for the hazard lights or as they are sometimes called, emergency lights.

User Avatar

There is no relay. The voltage comes from the fuse box directly to the headlight switch.

User Avatar

there is a fuse in the fuse box specifically for automatically turning on lights. I know this because I have my fuse removed. I don't want my lights on all the time.

User Avatar

the control panel on the rear lights goes bad. you can get a new panel on carstuff.com for cheap

User Avatar

In my 02 Aztek, I turn the headlight knob (on the dash left of the steering wheel, above your left knee) clockwise to get the interior lights to come on.

User Avatar

If you will notice the hazard lights are not actually flashing, reason being, the hazard flasher relay is defective. Replace it.

User Avatar

u have a blown headlight. change both bulobs and it will stop.

User Avatar

You have a bad relay. Your blinkers run on a different relay than you hazards do.

User Avatar

if you mean: "why do hazard lights flash when brakes are on", then the answer is because vehicles are equipped with a hazard light relay that supercedes the brake lights. This way, slow moving vehicles can operate under hazard lighting.

User Avatar

the location of the hazard lights is on top of the steering colum.

User Avatar

Hazard lights should be used if a vehicle is pulled over on the side of the road. If a vehicle is going slow when pulling something behind them, hazard lights should also be used.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.