your heat comes from your heater core which draws heat from your engine coolant so if you have no heat and the blower is still running then there is a coolant level problem as in none which then would cause the mottor to over heat and quick
Is it blowing cold air only or not blowing any air at all.
To stop it from blowing up.
because if you stop immediately then the car will stall.
Why would my 1984 Dodge pick up truck stall at the light when I stop
it means to stop blowing in his ear
You stop blowing up the world.
Could be,blown fuse, bad blower motor, bad switch, bad resistor,
it shouldn't stop blowing, but the compressor will shut off momentarily while you accelerate to get slightly more horsepower than it would with the compressor running
cause it's junk
i know the AC in my ZX2 stopped blowing because of a loose wire
The heater will stop getting hot when you're low on coolant. If the coolant is low enough the engine will overheat and it will be severely damaged.
Your Dodge Durango may stall when idling at a stop light for a couple of reason. One reason may be that a part needs to be replaced on the car.
why do u want it to stop blowing smoke man! blowing smoke is awsome and manly, and show power! be proud that your blowing smoke!
CHECK COIL PACKS
The wind has not stopped before but it can stop if we have no weather. For example, there would be no clouds, no rain,snow,hail,or other natural disaster, also the sky would not be blue. Most people say,"oh feel that the wind stopped"! But for the wind to stop there would be no weather and the earth would stop orbiting around the sun or on it's axis. There is a 99.9% chance that the wind would stop blowing.
torque converter is hangin up..
You need a tune-up
Several things can cause your car to stall and shake when you stop. Replacing the spark plugs and spark plug wires may cure the problem.
Make sure you have engine coolant. If the engine isn't getting enough coolant, it will overheat, stall and possibly destroy the engine. One symptom is that no coolant is circulated into the heater. Also check the crank sensor, but check coolant first...then the crank sensor.
could be that the choke is not adjusted right
if there heat would stop beating
I would suggest that the Choke is switching off and then the idle is set too low
Fix the fault blowing the fuse.
Fuse, switch, speed resistor or motor.