Car Fuses and Wiring
Buick LeSabre
Ford Explorer Limited
Turn Signals and Hazard Lights

Why would the turn signal not work if it is not the fuse located on a 1991 Buick LeSabre?

242526

Top Answer
User Avatar
Wiki User
Answered
2005-04-15 01:28:45
2005-04-15 01:28:45

Bulbs or turn signal flasher, maybe even the switch.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


More than likely the Flasher Relay is bad.

If the signal light fuse is blown all the signal lights front and rear would not work. If you have one signal light out I would first suspect a bad bulb or bad connection.

how much would it cost to replace the heater coil on a 1999 buick leSabre

A fuse usually blows when there is a short. It's possible you have a short in the wiring someplace.

Either the throttle plate is sticking or the idle air control is not responding to ecm signal.

It is under the front passinger side where they would put their feet bolted to the under caridge

I have a shimmy or small vibration while driving the interstate on my 1994 buick lesabre - if i was to check the front and rear bearings - how would i do that and what would i look for

what would cause a 1994 Buick LeSabre v6 to turn off going down the road.

I have a 95 Buick LaSabre Custom and the blower motor is located in the engine compartment center of where the dashboard would be. It has a electric plug attached to it and 5 bolts that hold the motor in place.

The spark plug gap for a 2003 Buick LeSabre should be set at .060 inches. The best spark plug for this vehicle would be an Iridium plug.

Ruin it the way you a "pimped out" car usually would be

I would highly suspect that there is a bulb out. Remove the Eight million hand tightened screws and the trunk lense will come out to access the socket. But check to see which one is out first.

Would have been built for R12, can be converted to R134a.

Would have been built for R12, can be converted to R134a.

you havent taken the key out of the ignition.

My 1993 buick lesabre rims fit perfectly on my dad's 96 ford ranger, so I would have to say yes.

It is important to know the cost of replace the parts of a car while owning it. The average cost to replace brake pads and rotors to a 1992 Buick LeSabre as a kit would be about $300.

Don't put a buick engine in a camaro. Instead, get a 350 LT1 (GM - corvette engine) for about 200 bucks used or 800 new. Sell the lesabre for this engine if you need to.

hi my car is leaking from the water pump so what can i do to stop leak ? and if i need to change the water pump would you guys tell me how can i change it?my car is 1997 Buick LeSabre v6 engine

The value would depend on the year, mileage, and condition of the vehicle. None of which you list. Therefore it is impossible to provide an answer.

No, these are likely completely different platforms, though I can't recall when the LeSabre went front wheel drive. If the engine is transverse, there are no compatibilities with a Caprice.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.