0
Add your answer:
Earn +20 pts
What would make a 1988 Oldsmobile cutlass ciera start and then die right away?
What would make a 1899 oldsmobile cutlass ciera start and then die right away?
Why would both headlights go out on a 1989 Oldsmobile cutlass ciera?
fuse
What would cause the blinkers to fail on a 1994 Oldsmobile cutlass ciera?
cracked or broken wiring, blown fuse
What weight oil do you use for a 1994 Oldsmobile cutlass ciera?
you would use 5W-30W have the same car
Where would you find the neutral safety switch on a 1992 Oldsmobile Cutlass Ciera?
It is incorperated with the PRNDL switch on the trans.
1990 olds ciera and you would like to know if it is front wheel drive?
The Oldsmobile Cutlass Ciera a was front wheel drive model. It was sold by General Motors from 1982 to 1996.
Why would the turn signal flasher in '90 Oldsmobile Cutlass Ciera still not work after being replaced?
do you mean you replaced the bulb? are the flashers out on both sides of the vehicle? did you check both front and back? do the lights on the dash do nothing or come on and stay on? you need to provide this information for a proper diagnosis
How do you disconnect the ABS in your 1996 Oldsmobile ciera sl?
The easiest method would probably be to remove the fuse, if it's a dedicated circuit.
Why does a 1996 Oldsmobile ciera SL car stalls while running and starts back up?
If it is stalling when putting it into gear but not while idleing I would check your mass air flow sensor. It may need to be cleaned or replaced. If it is stalling when putting it into gear but not while idleing I would check your mass air flow sensor. It may need to be cleaned or replaced.
What would cause a metal clanking noise in the upper engine in a 1992 Oldsmobile Ciera It's hard to start and it won't stay running.?
Had the same problem with my 92 cutlass ciera. It turned out to be ac compressor. Probably the clutch.
Will an alternator off a 1996 Oldsmobile Ciera 3100 engine fit a 1999 Chevrolet Malibu with a 3100 engine?
You would need to call a parts house and they can answer that for you.
Where would you locate the crank sensor on an 1988 Oldsmobile Cutlas Ciera?
On my 1990 the crank sensor is behind the vibration dampner. I just replaced it last week.Cost $35.00 at Auto Zone. Just be careful because you have to align the veins on the back of the dampner to go in between the grooves of the sensor.
