answersLogoWhite
Auto Parts and Repairs
Ford Escape XLS
Physics

Why would there be gas and water in the oil?

293031

Top Answer
User Avatar
Wiki User
Answered
2007-05-15 13:02:18
2007-05-15 13:02:18

to get both gas and water in oil, u most likely have a craked head crack will be right there at one of the valves

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Oil and gas are less dense than water therefore will separate and float.


the function of gas-oil separator is to separate the production fluids into their constituents such as oil, gas and water


It is the gas and the water that is in there


Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.Oil and gas.


water, gas, oil, antifreeze, ATF, brake fluid, gear oil, windshield washer fluid,



As long as the gas can was clean, then that would be ok.As long as the gas can was clean, then that would be ok.


The world would be dark, hungry, dirty and desperate without oil and gas


Natural gas and water may be produced along with the crude oil. For this reason, when the crude oil is produced, it must be processed and the gas and water separated out, so the oil can be sold to refineries.


Generally we refer to oil from a well as crude oil, but we referred to gas as produced gas. Most oil wells produce some gas. Natural gas from a well may require processing to remove contaminants and water. Natural gas from a well may require processing to remove contaminants and water.


First I would drain all the oil out. Put in new oil. Then take the spark plug out and crank the engine a couple times to get any water out of the cylinder. Then replace the spark plug. If any water got in the gas I would drain the gas and replace with fresh gas. I would also drain the float bowl of the carb to get any water out also if water got in the fuel. Then it should be ok to restart now. Good luck.


Yes possibly but i would look for smoke as well since oil will create smoke when burned. I would think that dirty fuel that clogs the filter, or water mixed with the gas might cause stalling and would also come from bad gas stations.


because oil has more fluid than water and more gas


If its producing water then its not a oil well there's water wells oil wells and gas wells Acidizing a well mostly after its been perforated will clean the perforations to allow a better flow of gas water or oil


you put all the gas from the petrol into a tube with water and then a spare tube will take the crude oil into it. so there you go.


If water was nonpolar it would be a gas at room temperature and would not expand upon freezing and so could not support life as it does. Edit Update: Plus, liquid water would then be able to mix with oil!


Gas is cleaner plus you don't have to have an oil tank with gas. On the other hand you would have less of a chance of an explosion with oil. So over all I would go with a heat pump.


No, oil will not dissolve in water, it separates.


50 parts gas to 1 part oil. So the amount of oil would be 1/50th the amount of gas.


Oil is less dense than water, so it would not be able to support what water cannot, therefore a sinker that sinks in water would sink in oil.


No, they are vastly different substances.


oil natural gas and water


Possibly the boiler is firing oil and thus the soot from the oil is spilling back into the gas flue



A reservoir drive mechanism is that mechanism in which oil is derived by water or gas or both water and gas drive the oil from the well. Is called reservoir drive mechanism.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.