Car Starting Problems
Jeep Cherokee Sport
Why would there be no spark when I have already replaced the coil the crank position sensor and the ignition module on a 1987 Nissan d21 pickup with 3.0 engine?
Asked in Nissan Maxima
Why is my Nissan maxima overheating already replaced thermostat?
Even though you have already replaced the thermostat, there are other issues that can cause your Nissan Maxima to overheat. Your fan may be stuck and not operating as it should. ...
How much does it cost to replace the ignition console on a 1994 Nissan Quest?
Well I had an ignition coil replaced in a 1990 Oldsmobile and the coil cost approximately $50. Labor would probably cost approximatley $35. ...
Asked in Nissan 200SX
How do you replace an ignition switch on a Nissan 200sx?
First you must start by removing the entire ignition, itself, on the Nissan 200SX. It should be fairly easy, you will just need the correct tools. Once you have bought the new ignition switch, attach it to the ignition and then re-install the ignition into the Nissan 200SX. ...
Where is the throttle position sensor located on a 2005 Nissan altima 3.5?
It's part of the throttle body, entire unit must be replaced.
Asked in Car Starting Problems, Nissan Altima
How do you know if the starter needs to be replaced on a 1993 Nissan Altima?
How do you know if the starter needs to be replaced on a 1993 Nissan Altima? ...
Asked in Nissan Maxima
How do i Disable the anti-theft in 2000 Nissan Maxima?
To disable the anti-theft in a 2000 Nissan Maxima, put the key into the ignition, but only turn it halfway. Leave it in this position for several minutes and start the car. ...
Asked in Nissan Quest, Nissan Altima
How do you change the ignition switch on a 93 Nissan quest?
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch. ...
Nissan D21 z24 Pickup It cranks won't start no spark getting plenty of fuel just replaced ignition module still won't start?
have you replaced and or tested both coils? are you getting no spark on the intake and the exaust sides? ...
What is a interlock switch on a 1992 Nissan 4x4 truck?
If you turn the ignition to the on position, and then press the interlock button, you don't have to press the clutch pedal down to start the truck. ...
Asked in Car Starting Problems, Nissan Maxima
Why does your 1999 Nissan maxima security light flashes when ignition is offthen goes solid on with ignition on and while crankingand car will not start?
I forgot to tell you after you connect the battery with the key in start position try to start the car after you reconnect the battery ...
Asked in Mercury Villager
Find camshaft position sensor on a 3.3 Nissan engine?
The camshaft position sensor is an integral part of the distributor. If codes and tests indicate that it is faulty, the distributor must be replaced. Last I looked a cheap one was $1,500. ...
Where is the ignition switch located on a 1986 Nissan 300ZX?
when you start the car up that's your ignition switch is located...