You size wire by the current. Various insulations are rated for voltage, temperature and the medium where the wire will be run.
Yes <<>> In North America, a three wire 120/240 volt system uses a neutral wire. For 240 volts two "hot" wires are used with no neutral.
Depends on the amperage of the Jacuzzi and if it is 120 or 240 volts.
AWG # 10.
At the service entrance you will need AWG 1/0 gauge.
10 mm2 cross section should be sufficient (#6 wire?)
240
30 amps.
At 120 Volts you would draw about 42 amps. At 240 Volts it would be about 21 amps. For 120 Volts you would need 6 AWG and for 240 Volts you would need 10 AWG.
Yes <<>> In North America, a three wire 120/240 volt system uses a neutral wire. For 240 volts two "hot" wires are used with no neutral.
current = voltage/resistanceAssuming the 240 volts is across the 100 ohm wire, 2.4 amperespower = current * voltageResulting in the wire dissipating 576 watts... One hot wire!
5 amps
3/0 wire 3/0 wire
A #14 wire will do the job.
A label.
If you are connecting 120 volts, you connect the black wire to the breaker, white wire to the neutral bar, and ground wire to the ground bar. If you are connecting 240 volts connect the black & white wires to the breaker, & ground wire to the ground bar.
No, the dryer needs 120 volts supplied by the neutral third wire, along with the 240 volts for the dryer element. One of the two 240 volt supply conductors is used with the neutral to supply 120 volts to the controls and the drum motor. That is why a three wire cable is needed.
10 gauge