It will bolt up, but it will not shift. 1997 is electric, 1994 is hydraulic
No, it will bolt up, but it will not shift. The 1995 is hydraulically controlled. The 1997 is computer controlled.
The governor sensor has to do with transmission fluid pressure.
The engine computer is the voltage regulator in a 1997 Jeep Grand Cherokee.
Any thing is possible, but the 1990 318 is a different block than the "Magnum" 318 that was available in the Grand's.
42RE if it's an automatic, Aisin AX-15 if it's a manual.
A 1997 Jeep Grand Cherokee does not have EGR.
How do you change the orifice tube on 1997 grand Cherokee jeep with 5.2 v/8
The transfer case in a 1997 Jeep uses automatic transmission fluid.
The crankshaft position sensor on a 1997 Jeep Grand Cherokee 4.0 L is on the top driver side of the transmission bell housing.
The governor pressure sensor is on the passenger side of the valve body inside the transmission.
A 1997 Jeep Grand Cherokee has one ignition coil.
On the V8 it is on the passenger side top of the transmission bell housing, on the six cylinder it is on the driver side top of the transmission bell housing.
The jack is located under the rear seat on my 1997 Jeep Grand Cherokee.
some are yes but the sensors have different connections
yes it will bolt right up
i need to disable jeep factory alarm 1997 cherokee
Wrangler up to 2006, Cherokee up to 2000. Grand Cherokee up to 2004.