answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2006-07-24 08:43:43

Definetly not.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

What is meant by cross flow radiator?

The radiator tanks are vertical, one on each side and the radiator core tubes are horizontal.


What do you get if you cross a sheep and a radiator?

Central bleating


What is the symbol of Saturn?

the symbol of Saturn is like a little cross connected with a Ear or question mark not a H.


What are the two planets that have orbital paths that cross each other?

Jupiter and Saturn that cross each other.


If there is oil in the radiator of a 92 Camry v6 and head gaskets arent blown what could be the problem?

Cross contamination of transmission fluid within the radiator. Replace the radiator.


What is the fram oil filter cross reference for Mitsubishi part 30A4000103?

19682581000


What would a cross section of Saturn look like?

it is like cutting Saturn in half then labeling the atmoshere, rocks,etc


What is the fram oil filter cross reference for Mitsubishi part smd360935n?

Fram PH7317


How do you remove the radiator off a 1998 Lincoln continental?

You would remove it from underneath. There is a cross member which holds the bottom of the radiator and you remove this, after unhooking all the lines (trans coolant and engine coolant) and draining the radiator.


What is the fram cross reference for a Mitsubishi oil filter 31s94-02160?

I could not find a direct cross reference, but on the filter itself was a DENSO # of 115010-5350 and that has a WIX cross reference number of 51056


Is there a fram oil filter cross reference for the Mopar 04892339AA oil filter?

The Fram oil filter cross reference guide lists Fram's PH10060 as a cross reference for Mopar/Chrysler/Mitsubishi 04892339AA.


What would make hot water leak under car?

misplaced radiator cap - buy a new onecross threaded radiator cap - take off and put on properlyhole in radiator - drain the radiator of coolant, solder the hole closed, refill the radiator.worn-out water pump - buy and install a new or rebuilt one.hole in radiator hose - buy and install a new one.


How do you replace a radiator on a '91 Thunderbird supercoupe?

To replace a radiator on a 1991 Thunderbird Super Coupe, a person has to drain the old radiator, then unhook all of the hoses. The radiator is bolted to the cross beam in the front and held in by bolts and screws along the sides and bottom. It is a good idea to take a picture of the old radiator and hoses to use as a reference when installing the new one.


Where is the windshield washer reservoir on a 1997 ford thunderbird?

The reservoir cap (that's about all you can see of it) is in the front of the engine compartment, in front of the radiator cross brace, on the drivers side of the car just to the right of the radiator.


How is Saturn environment different from the of Earth?

Saturn is much much colder. It is a gaseous planet so there is no "dry land". The entire planet is sort of like a cross between an ocean and an atmosphere, with large storms that flow through.


Are Mitsubishi parts compatible with eagle talon of same year?

Usually yes but you have to cross reference the model types to see if they have the 4g63 or the 420a motor


Where is the bcm module on 2001 Saturn SC1?

Saturn Shop Foreman here. Located under the dash cover on the cross car beam. Must be programed by GM dealer, holds Odometer information as well as other functions.


How do you rotate tires to a 2005 Mitsubishi Endeavor?

Rotate rear tires to front and front tires to rear. Keep the tires on the same side of the car and do not cross them.


Torque Specs for Valve cover on 1994 Saturn?

Same torque for a sparkplug should be fine. Criss cross patters should be used


2000 Chevy venture how to remove radiator drain plug?

The radiator drain plug on a 2000 Chevy Venture is removed by slowly turning it in a counter-clockwise direction. Care must be taken when re-installing the plug to prevent cross threading.


How can water get in a transmission?

This is pretty much a no brainer. Transmission cooler section inside your radiator is bad or you have tried to cross a flooded creek with 3' of water.


What is the cross section of Saturn?

The interior of Saturn is probably composed of a core of iron, nickel, silicon and oxygen compounds, surrounded by a deep layer of metallic hydrogen, an intermediate layer of liquid hydrogen and liquid helium and finally, an outer gaseous layer


Replacing radiator 1993 S 10 Blazer?

If you have a 4.3 vortec,Locate and open radiator drain plug into container. (apx 3 gallons) Remember antifreeze is posion!!! Remove radiator cap. Loosen intake hose clamp, Loosen the two wing nuts on the plastic part of the air intake atached to the top of the radiator and remove. Loosen the radiator clamps and remove the hoses from the radiator. Loosen the two transmission lines.(DO NOT BEND if possible) Remove the two bolted clamps on the top. Carefully lift straight up and out.When replacing, be carefull not to cross-thread the transmission lines.


Chrysler cirrus radiator?

Disconnect the negative battery cable, tape it up with electrical tape and tie it out of the way; remove 4 bolts that hold the upper cross member on top of the radiator, the plastic fasteners that hold the upper portion of the grille, the upper and lower radiator hose, 4 bolts that holds the aircondition condenser on to the front of the radiator, cooler lines bracket on left and right side of the radiator, a bracket that holds the aircondition line to the fan shrod, unplug the cooling fan connection wires. Then remove the radiator and fan as a unit, you can separete them after u get them out;


How do you remove the radiator in a 1993 mercury topaz 6-cylinder?

# Disconnect the negative battery cable # Drain cooling system # If equipped remove the plastic shield over the radiator # Disconnect the electric cooling fan motor wires and A/C discharge lines if equipped # Disconnect the overflow hose from the radiator filler neck # Remove the upper hose from the radiator and engine block # Remove the 2 fasteners retaining the upper end of the fan shroud to the radiator and sight sheild # If equipped with A/C remove the nut and screw retaining the upper end of the fan shroud to the radiator at the cross support and nut and screw at the inlet end of the tank # Remove the fan shroud by carefully pulling the unit up and out of the car # Remove the 2 nuts retaining the top of the radiator to th radiator support if the stud loosens make sure it is tightened before the radiator is installed # Remove the clamp which secure the lower radiator hose to the radiator # Tilt the top of the radiator rearward to allow for clearance with the upper mounting stud and lift the radiator from the car.Make sure the mounts do not stick to the radiator lower mounting brackets