I need to find a tire carrier for a 2004 nissan frontier 4x4 under the bed
there are 2 bolts on the side of your bed inside. its a 10mm bolt, unscrew and then the light comes out.
There is no question here!
no its a different body style
I believe you have to unscrew a couple bolts on the inside of the truck bed to get the taillight assembly off the truck then you can unscrew the light sockets and replace the burnt out bulb
You are going to have a hard time finding a cargo liner for a Nissan Frontier. The cargo liners are only for station wagons, SUVs and Crossovers. You might mean a bed liner.
Go to the in side of the bed and the are two screws and the it pop off
remove the 2 screws from inside the bed(if you have a bedliner you may have to pull up on the bedliner to see them) once you have those out, it should just pop out, and the lights unscrew from the back of the assembly
easiest safest and fastest way is to simply unbolt bed disconnect taillights set bed back and its right behind drivers side . i did mine in less than an hour and ahalf it took four of us to set bed back and reinstall clean job...
Under vehicle, passenger side, below bed area mounted in fuel line.
in back in gap between bumper and bed there should be a slot for jack handle to fit through to crank
The factory bed liner needs to be flexed around the upper cargo hook to gain access to the two hex head screws that hold the tail-light housing against the body.