0
On a non-TBI engine, Yes.
Wiki User
∙ 14y ago
Johnny Garrett
Johnny Garrett
Add your answer:
Earn +20 pts
Can you use a 350 Chevy intake manifold on a 283 Chevy?
yes
Which motor has an intake manifold number of 14057055 With an exhaust casting number of 14079205?
Intake Manifold 140557055 is for a 283 SB Chevy.
What are the intake manifold torque specs on a 1965 Chevy 283?
30 ft/lbs on a cast iron intake.
Where is a oil pressure sensor located on a Chevy 283?
one of two places either on the back of the intake or under the exhaust manifold It is on the rear of the engine behind the distributor.
Does the 350 CID small block Chevy motor have the oil fill tube in the intake manifold?
No. That would usually be a 283, 307, or 327.
Does a 1967 Chevy 283 have an egr valve?
NO if it has the stock intake manifold, if you have an after market intake manifold like I do, then good luck finding it....I'm still looking for one. Also it should be right up front to the left of the thermostat housing. Good luck, Tarlak
Picture or diagram of a Chevy 283 engine?
http://www.classiccarauto.com/impala/how_to/images/distributor.png
Are Ford e-150 engines 283?
No, Ford has never built a 283. The 283 is a Chevy engine.
What type of Chevy aluminum intake manifold with casting number 3746829?
1958 - 61 Corvette and Passenger 283 CI motor with Rochester WCFB , Carter 4 barrel or Carter WCFB.
What is the firing order for a 283 v8?
The firing order, which should be cast into the intake manifold, for the Chevy small block V8 is 1-8-4-3-6-5-7-2
What is the difference between 350 Chevy engine and 283 Chevy engine?
Physically, they are the same exterior dimensions, but that's about it. Bore and stroke are different, rod journal diameter is smaller on the 283, heads bolt on, but no accessory mounting holes in 283, balancer is different. Carb and intake would interchange, distributor fits, bell housing bolt pattern is the same.
Can you use a 283 intake manifold fit on a 350 Chevy engine?
Yes, as long as it is a pre 87 350. In 87 Chevy changed the cylinder head configuration, and thus takes a different intake. The only isue here is the place you put the oil in. On early 283's, there was a hole in the front of the intake, to put a tube, to put opil in. There were no holes in the valve covers. Newer stuff, they eliminated that hole, and you put oil into the valve covers. Just make sure you have the proper set up. It does not matter where you put the oil, either spot, but, just so you can.
