Sure will if they are both small blocks. Never change the bell housing bolt pattern. Im asuming your Chevy c10 probably had a straight six, a three fifty, or a 305. It will be same as a 1992 350, 305, or a 4.3l. Just make sure the flywheel is right for the motor, depending if it is internatly balanced or externaly.
Mercon works.
It should be mounted into the drivers side rear of the transmission.
no
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
If the heater fan is not blowing on a 2001 Chevy S10 Pickup, it is possible that the fuse needs replacing. It is also possible that debris is interfering with the operation of the fan. Could also be, a faulty fan motor, a faulty fan motor speed resistor, a faulty fan motor switch,
An autimatic transmission will have a 4 speed transmission and a manual transmission will have a 5 speed transmission.
2000 lbs according to specs on the kbb.com web site
The blower motor relay only operates the high speed function. That relay would be in the fuse/relay center under the hood.
It is important to maintain the fluid levels in a car, and it is important to put the right type of fluids in the car as well. A 1989 Chevy Pick up uses Dexron III transmission fluid.
Where is the idle speed motor located at on a 1995 chevy blazer?
Its mounted on the transmission.
where is the speed sensor for the transmission located in 2001 chevy venture