answersLogoWhite

0


Best Answer

not usually. warped rotors will cause a vibration during braking.

User Avatar

Wiki User

โˆ™ 2006-09-23 04:45:12
This answer is:
User Avatar
Study guides

best car workshop in dubai

โžก๏ธ
See all cards
โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…โ˜†โ˜…
No Reviews

Add your answer:

Earn +20 pts
Q: Will a broken motor mount cause the front end of a vehicle to shake when braking.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where would inertia cause the weight of a vehicle to shift during hard braking?

To the FRONT of the vehicle


When front suspension compresses the vehicle is?

Probably braking hard.


What would cause a vehicle to shake after hitting left front tire on curb?

Possible broken a-arm, or bent wheel.


What will cause a front end to shake on a Chevy Colorado when braking?

warped rotor


How much of the braking is typically done by the front brakes in a front-wheel-drive vehicle?

10% 30% 50% 70%


What will cause a front end to shake violently on a dodge Dakota when braking?

replace front brake rotors and pads.


What percentage of the braking force comes from the rear brakes in a typical front wheel drive vehicle?

If memory serves, the typical braking force ratio for any automobile with front disc and rear drum brakes is 60% front, 40% rear +/-.


what would cause a rubbing noise on drivers side front wheel especially when braking ( I replaced ro?

what would cause a rubbing noise on drivers side front wheel especially when braking ( I replaced rotor and wheel bearings are good) ?


What percent of braking are Front wheels responsible for?

What percent of braking are front wheels responsible


What is the difference between primary brakes and the secondary brakes?

Primary brakes are situated at the front wheels and provide about 70% of a vehicle's braking power. Your secondary brakes are located at the rear wheels and only provide about 30% of a vehicle's braking power.


What are EBV in a car?

EBD: Electronic Brake Distribution (or Electronic Brake-force Distributor) - alters how much of the brake force goes to the front and how much to the rear. Cars always have more braking on front as if the rears lock before the front then the car will spin. How much braking you can do with the rears depends on how much weight is in the vehicle so EBD dynamically adjusts this balance. Without it, the manufacturer sets up the balance so the rears don't lock when the vehicle is empty which is less braking than is possible when the vehicle is full.


What has more stopping power front or rear brakes?

There should be more braking power to the front wheels for two reasons. As the brake is applied there is a change in the balance of weight distribution on all four tires caused by the vehicle pitching down on the front. This places more weight on the front tires. If there was more braking taking place on the rear tires than on the front, there would become an oversteer condition and the back of the vehicle would skid out.

People also asked