No it will not run at all
The tuck will run forever.
No. If it did crank over it wouldn't be seized.
If you want to make sure it is seized. Remove the spark plugs. Take off the starter and try to pry engine to move, with out damaging the teeth of the fly wheel, with a lever. or take off timing chain cover and try to turn engine manually. If you can't budge at all, then your engine is seized. When you run an engine long enough with no oil and then stop engine. Piston's actually weld (seize) to cylinder wall. REPLACE ENGINE...
Without an oil filter in place the engine oil would just be pumped out of the engine , so the engine would run until the engine seized
The engine has seized up! Pirates have seized the port!
a seized engine will not turn over. Even using a socket and ratchet on the crank bolt, the engine is not going to move. It is frozen, or seized up.
When an engine is seized up, it will not turn over. The crank cannot make a rotation. Take hold of the main pulley and try to turn it. When you cannot turn the engine over, it is seized.
If the engine isn't seized up and you check your gas and oil.
Piston seized to cylinder wall Broken Crankshaft
A seized engine is usually very obvious. The starter cannot turn the engine at all. Of course, you do need to first eliminate the possibility that the starter motor has failed and the engine is undamaged. The main resistance to the starter motor is compression, so you should remove all spark plugs, so there can be no compression, and the engine will normally then turn over very easily. If it still does not turn over using the starter then it is probably seized.
It is required for a computer controlled engine to run at all.It is required for a computer controlled engine to run at all.
Normally when an engine is "seized up" it is frozen to the point that the crankshaft will not turn in the bearings. This is caused by heat most times the car has been run low or out of oil. The parts that have seized or melted together could be main or rod bearings, piston rings etc. If the engine will not turn over by hand it probably time for a complete rebuild or a new engine. Sorry