answersLogoWhite
Chevy S-10
GMC Sonoma
DirecTV

Will a vortex out of a 94 Jimmy be a direct fit into a 91 GMC Sonoma?

464748

Top Answer
User Avatar
Wiki User
2008-01-15 02:44:05
2008-01-15 02:44:05

I assume you are suggesting swapping a 4.3 liter Vortec engine into a '91 Sonoma that has a 4.3 liter engine. I believe this would be a major project. The '91 4.3 liter has a TBI fuel injection system and the Vortec uses a different, higher pressure system with injectors at each cylinder. I think you would need to change the fuel pump in the fuel tank, computer, harnesses etc. The Vortec also uses a mass air flow sensor so the air induction system would also need to be changed. Not compleley sure on all the changes necessary but I do believe it would be complicated. I just finished swapping a '90 4.3 into a '94 Sonoma. Both are TBI injected. One thing to watch -- the OIL PAN. The oil pan on the four wheel dirve version has a shorter, deeper sump to fit around the front drive axle. The 4WD version will probably work on a 2WD but I would check it out. Good Luck, Jim

1

Related Questions

User Avatar

It is in the rear left side in a removable panel in the glovebox of my 1995 [manufactured 8/94] GMC SLS Sonoma, 4x4, 4.3 vortex; hopefully, it is in the same place in yours...

User Avatar

No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.

User Avatar

The S10 Blazer, the S10 pickup, the GMC Sonoma, the GMC Jimmy, the Oldsmobile Bravada.

User Avatar

The GMC S-15 became the GMC Sonoma in 1991.

User Avatar

Where is the timing connector on a 1995 gmc sonoma

User Avatar

will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4

User Avatar

How do you flush the raditor on a 1992 GMC Sonoma Pickup.

User Avatar

where is the iat sensor located on a 2003 gmc sonoma truck

User Avatar

Yes, but there's no guarantee that the ratios will match up... the Sonoma might have, say, 3.73 rears while the Jimmy has 3.42s (standard for the Blazer, Jimmy, and Bravada for that model year)... you'll have to look at the RPO codes in the glove box to determine this... 3.42 rears will have a GU6 RPO code.

User Avatar

what are the torque specs for a head on a 2.2 liter gmc sonoma

User Avatar

On the sides of the engine block

User Avatar

I drive a 2000 gmc sonoma. My jack is behind the passenger seat in a built in box. Hope this helps.

User Avatar

You can find a diagram for a 1997 GMC Sonoma in the owner's manual. You can also find it at various auto stores.

User Avatar

235/55/16 is stock on a 2000 gmc sonoma...tough size

User Avatar

"I have researched the GMC Sonoma and have found that this model is no longer available. I am sure that you have the option to purchase a used GMC Sonoma but the price for the vehicle will depend on factors such as the year, condition, mileage, and vehicle options as well as where you are purchasing this vehicle."

User Avatar

there is no cut off switch on a 1999 gmc sonoma

User Avatar

what are the symptoms of a bad fuel pump on a 2002 GMC Sonoma 4.3 liters?

User Avatar

The 2000 GMC Sonoma has four speakers with the standard sound system. An upgraded sound system came with six speakers.

User Avatar

The Cam Sensor in a 1996 GMC Sonoma is located in the distributor under the rotor cap

User Avatar

where is my voltage regulator located on my 1997 gmc jimmy

User Avatar

where do you put freon in on a 2000 gmc jimmy


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.