0
Will engine click or knock with bad intake manifold gaskets?
Fz5zcw
No, normally the engine will idle very rough and then run good at full throttle when the intake gasket is leaking. Spray around the edge of the intake with carburetor cleaner, engine running. When you hit the spot with the leak the engine will rev up. A click can be valve train noise caused by a valve that needs adjusting or a sticking lifter. A knock is usually caused by worn bearings.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Ford 5.4intake manifold torque specs?
Click this link or paste it into your browser. The answer is here. http://www.f150online.com/forums/engine/152892-lower-intake-manifold-torque-specs.html
What does check engine code t0660 mean for 2003 Mazda protege 5?
If you mean PO660 it is Intake Manifold Tuning Valve circuit Malfunction. Click the link.
Where is the crankshaft position sensor located on a 2005 altima?
It's bolted on the lower part of the engine block, close to the oil pan. Also close to where the transmission/transaxle is bolted to the engine block. Rear side of the engine (same side as the intake manifold). You have to push and hear the click before disconnecting the connector.
Why does the idle go up and down on a 1994 civic ex?
Look for a cracked, broken, or disconnected vacuum hose coming from the intake manifold. Also make sure the intake tube going to the air cleaner does not have any holes letting air in. Click the link.
How many cylinders move in the intake stage on a car engine?
All cylinders are moving at the same time weather it is on the intake or exhaust stage. The valves close and open in cycles. Click the link to learn more.
Why does my car smell like play-dough while running?
Click and Clack just answered a question like this on their radio show. Although the question was somewhat different, I think the answer may be the same. Have a mechanic check your engine gaskets to see if antifreeze is leaking into the engine.
What is the torquing specs for the bolts on a 1999 blazer 43 intake manifold The book gives 132 pounds but this seems too much?
I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)
Are their any recalls for the 2008 Nissan versa's for blown head gaskets and cracked blocks?
Click the link.
How do you change the valve cover gaskets on a Cadillac 6-cylinder engine?
Go to www.autozone.com (might be .ca) In upper left corner, click on repair guides. Select your make model and year. Vehicle selections are on the right, (engine, electrical, etc.) This site is seriously what mechanics use to fix your car...and they bill you$90/hr to surf the web.
Is the petrol engine is the otto engine?
A petrol (gasoline) engine can be an otto cycle engine or it may not be. Click the link.
Where can you get the timing diagram for '98 Kia?
Go to kiatechinfo.com register as owner, select year and model, click service manual, click engine, click engine mechanical system, cilck timing system, click timing belt, click repair installation/removal, click installation,done!
What is the purpose of engine cylinders?
Click the link.
