In the thermostat housing at the front of the intake manifold.
Should be on the front and left side of the flywheel housing.
right front below headlight housing,,,drivers side!!
It comes out the back of the light housing.
It does not have one. It has a 4x4 Actuator in the front housing.
On the intake manifold up front by the thermostat housing to the left of it.
Up front, on top of the engine, next to the thermostat housing.
If you'll lay under neith the front housing towards the drivers wheel and look up at the housing you will see a plug on the side towards the bottom, Take it out.
Pull the torque convertor out, they are on the front of the tranny inside the bell housing.
On the front axle, passengers side of carrier housing.
If you will look at the bottom radiator hose you will see were it clamps onto a housing on the front left lower part of the engine. That housing will have 2 bolts that hold it to the engine. That is were the thermostat is at, behind that housing.
If you follow the lower radiator hose to the left front side of the engine you will see where it clamps onto a housing on the water pump, It is behind that housing. Remove the 3 bolts that hold the housing on and it will be there.
It is in the front differential housing. Craw under the front of the truck and look at the housing towards the passenger side and you will see it. It will have electric wires going to it.
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
Get under the truck. Look at the front of the bellhousing, on the passenger side of the vehicle. You'll see the starter sticking out of the front of the bell housing there.
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
NO it don't. The actuator is up on the front axel housing. Now the transfur case does have a switch on it that sends power to the actuator up front.
on the back of the block where the belt housing bolts on and also on the front in front of the passenger side head there is a ledge that has a number there unless the block has been decked
The 4x4 actuator is screewed into the front differential housing towards the passanger side, It has electric wires going to it,
It's usually screwed into the intake manifold towards the front, near the thermostat housing.
Just follow the TOP radiator hose to the top front of the engine and you will see were it clamps onto a housing that has 2 bolts holding it to the intake. It is under that housing.
Follow the top radiator hose to the front top side of the engine and you will see were it clamps to a housing that is held in place with 2 bolts. it is under that housing.
take off the right front tire. Straight in where the axle goes into the housing. Its right on top of the housing just a little to the left. Glad to help. Bill
The 1994 Chevrolet Beretta thermostat is located on the front of the engine. You can follow the top radiator hose directly to the thermostat housing. The thermostat will be in the thermostat housing.
Look at the front part of the rear end where the driveshaft bolts to it and you will find it in the housing. It will be on the passenger side of the rear end housing where the driveshaft hooks to the rear end.