answersLogoWhite

0


Best Answer

I am converting a Ford Ranger automatic (a4ld) transmission 4wd to a 5 speed manual from a 4 cylinder Ford ranger. Will it work. What is needed?

User Avatar

Wiki User

โˆ™ 2009-06-24 20:21:11
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Will the manual trans from a 4-cylinder Ford Ranger bolt up to the bell housing of a 6-cylinder Ford Ranger?
Write your answer...
Submit
Related questions

Were is speed sensor on 1999 Ford Ranger manual transmission?

its on the rear axle housing


What are the bolt size for manual transmission bell housing for a 94 ford ranger?

15mm and 13mm for starter bolts


Where is the clutch slave cylinder on a 1993 ford ranger 4x4?

I believe that is inside the manual transmission bell housing


Where is a slave cylinder on a 95 ford ranger?

The slave cylinder for a hydraulic clutch is inside the manual transmission bell housing


Where is the slave cylinder in a 1985 Ford Ranger extended cab truck?

The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing


Where is Mass flow sensor location for 2003 Ford Ranger?

The Mass Airflow sensor (MAF) is located between the air filter housing and the air intake duct. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.


Will a manual five speed transmission from a 2003 Ford Ranger fit a 1991 Ford Ranger pick up?

No, the 2003 manual transmission will not fit a 1991 Ranger.


What service does a 2004 Honda accord 4cylinder needs?

Everything that needs to be done is listed in your owners manual under the maintenance schedule.


Does anyone have manual instruction on how to install an exhaust manifold on a 98 iszuzu rodeo 4cylinder 2.3 liter 5 speed?

Nope.


Diagram to ford 1997 ranger?

The diagrams of the different systems in a 1997 Ford Ranger can be found in a Ranger service manual. The manual is available for purchase in most auto parts.


1990 Ford Ranger manual?

A person can get a 1990 Ford Ranger manual directly from the Ford company. You can visit a dealership near you and they can order the manual or print one off for you.


Need a auto manual for your 2001 Automatic 4cylinder 1.8turbo Quarto?

[http://www.themotorbookstore.com/audi1.html Look here] Hope This Helps


What type fluid is used in 1993 ranger manual transmission?

I know that a 1994 ranger with a manual trans. uses automatic trans. fluid


How do you put a headlight housing into a 2002 Ford Ranger?

Per Haynes Ford Ranger Pickups Repair Manual: Steps for removal are: (1)open the hood; (2)unscrew the retainer from the back of the headlight; (3)pull the bulb socket out of the headlight assembly; (4)pull out the housing clips and remove the housing from the grille opening;(5)NOTE: on later models, there are only two clips that are pulled up to release the headlight housing. They are located on the back of the housing - one on each side. After pulling them up, simply move the headlight housing forward from the vehicle. (6)the steps for installing it back are the reverse of the removal steps.


What type of fluid for a 1999 Ford Ranger manual transmission?

Motorcraft MERCON ATF ( automatic transmission fluid ) is used in the 5 speed manual transmission of a 1999 Ford Ranger , according to the owners manual


Where can you find the fuse in a 96 ranger that operates the 4wd switch it won't enguage manual light 4wd low4wd blinking?

On a 95 ranger, the 4wd actuator needed replacing. on a 95 ranger, the 4wd actuator needed replacing. However, you can put it in 4wd and tap the from housing and it will sometime go into gear. The lack of use causes the actuator to freeze-up.


How do you replace the head lamp bulb on a 1994 Ford Ranger?

(1) Open the hood; (2)unscrew the retainer from the back of the headlight; (3)pull the bulb socket out of the headlight assembly; (4)pull out the housing clips and remove the housing from the grill. NOTE:on later models there only 2 clips that are pulled up to release the headlight housing - one on each side. After pulling them up, simply move the headlamp housing forward from the vehicle. It may also be necessary to remove the headlight housing to change the bulb. - Haynes Repair Manual #36071; 1993-2005 Ford Ranger Pickups.


Where is the thermostat located on a 2000 Ford Ranger?

The Haynes manual I have says the thermostat housing is located between the lower radiator hose and the block on the left front side of the engine. The thermostat and housing are all one piece. The lower radiator hose (return) connects to the thermostat housing. follow the out hose for the rad until it enter the block it shouldn't be hard to find.


Is there a free online shop manual for a 92 ford ranger?

There are a number of free online shop manuals for a 92 Ford Ranger. The Ford Ranger online store is your best bet on finding the manual.?æ


What does the manual transmission take for oil in a 1997 Ford Ranger?

Motorcraft MERCON automatic transmission fluid is used in the 5 speed manual transmission according to the 1997 Ford Ranger owners manual


Manual transmission fluid capacity 98 ranger?

According to the owners manual , the 5 - speed manual transmission on a 1998 Ford Ranger takes 2.8 quarts ( 2.65 liters ) of Motorcraft MERCON ATF ( automatic transmission fluid )


Where can you download a parts manual for a 2000 Ford Ranger?

Look up 2000 Ford Ranger in the RockAuto.com parts catalog and find repair manuals under Literature. The 2000 Ranger repair manual is on DVD - ROM for about $14.


How can you find a manual to change a clutch in a 2001 Ranger?

www.helminc.com You can find a shop manual for a lot of vehicles.


Where can I find a diagram for the fuse box of a 1994 Ford Ranger?

look in the owner's manual for any `94 ranger, or buy and inexpensive automotive repair manual for ford rangers.


Can you use or convert a 5 speed manual transmission not 4x4 for a 4x4 5 speed manual in a 1988 ranger if so how?

No you cannot. The outut shaft on a 4x4 is different then the output shaft on a two wheel drive. they have different spline counts and the 4x4 Tranny has a different extension housing to bolt the Transfer case to.