0
Depending which circuit burned out, yes.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Why do the gauges on a 1984 Corvette stop working?
There are numerous reasons that can cause the gauges to stop working. In my case, I found a pin on one of the printed circuit boards that had never been soldered. This pin supplied 12 DC power from one board to the other and was black from arcing over the years. This was an intermittent problem that would cause the gauges to come and go. I soldered the pin and the instrument cluster has been working flawlessly ever since. Bad grounds are often the cause for electrical problems in Corvettes.
What do you do if your car gauges stop working?
check your fuses first
What makes the intrument gauges stop working?
check the ground sprats
What are common causes for mechanical gauges to stop working?
Bad electrical connections.
Do the gauges have a fuse all gauges stop workin at one time.?
Yes, some vehicles have one fuse that protects the gauge/dash cluster circuit.
Tempfuelvoltage gauges stop working 2000 Chevy s10 pickup?
Check the fuses.
Why did my fuel and temperature gauges stop working on my 1992 Toyota corolla?
One reason why fuel and temperature gauges would stop working on a 1992 Toyota Corolla would be a short in the wires. This would lead to a blown fuse. Check the fuse and replace it.
What causes your gauges to stop working?
The year, make and model would help but with some vehicles all the dash cluster gauges are protected with one fuse.
What are the advantage to a parallel circuit?
If one wire was to break only one of the bulbs on the circuit would stop working whereas if one wire broke on a series circuit all the bulbs would stop working.
What is wrong when your gauges on dash board stop working on your 1997 Chevy astro van?
what is wrong when your gages on dash board stop working on your 1997 chevy astro van?
Would a cancel switch make the gauges on your 1987 samurai stop working?
If the Gauges on your instrument panel have stopped working you may have had a voltage converter stop working. This device mounted to the rear of your instrument panel converts the voltage from your alternator to the voltage that your gauges run off of. You can check the fuses with a multimeter and see if both sides have voltage showing, if so then see about replacing the voltage converter.
If a circuit had a gap in it would it work?
Nope... if the circuit has a gap in it - the path of electrons is interrupted, and that would stop the circuit from working.
