There is about a 1 1/2" difference in the location of the tranny mount. You will need to modify the Cross member which holds this mount. Other than that it will fit.
The 1985 Chevrolet S10 light truck came factory equipped with the 2.8L 6-cylinder (engine code 'B') in both automatic and manual transmission options. The manual transmission type was the 5-speed F5M22-2.
The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing
on e bay ,look for the service manual,i have one.
I believe its Dexron ATF fluid. Check the owners manual if you have one.
The adjustments are pretty obvious on the the top of the transmission under the air intake and exhaust plumbing.
Yes, you can put any other speed tranny in as long as the bolt patterns match. What this means is that you have to find out what other transmissions your engine will accept. Then you can choose from those.
I need to know fluid type speccifications for manual transmission Chevy 1985 s-10 5spd Chevy 1985 s-10 what type of manual transmission fluid
The adjustments are pretty obvious on the the top of the transmission under the air intake and exhaust plumbing.
Motorcraft.com shows for a 1985 Ford Truck with 300 cubic inch ( 4.9 L ) straight 6 cylinder ( 10 degrees BTDC ) - doesn't specify automatic or manual transmission
on the transmission. and it requires gear oil
You can put any SAE certified transmission fluid in the transmission of your 1985 five-speed Chevette. The transmission holds nine quarts of fluid.
No it did not, Automitac only